1/2x28 to 5/8 Adpater

[Gstew1930]

Has anyone see any negative affects of accuracy from using an adapter? My tikka ranch came with 1/2x28. I dont have a suppressor that will fit

 

[Pickettpuncher]

I use an adapter, no issues

 

[mxgsfmdpx]

I had our machinist make me an adapter. You don’t need anything fancy. I’ve seen folks use and like the Hughes Precison units.

 

[Gstew1930]

I had our machinist make me an adapter. You don’t need anything fancy. I’ve seen folks use and like the Hughes Precison units.

Thank you

 

[TreeDog]

Down Range Products is another one. Zero issues

 

[wesfromky]

Currently out of stock, but I got one of these and it was pretty burly. The wrench flats are nice.

1/2-28 to 5/8-24 Adapter - Silencer Shop

These custom thread adapters can be used to 1/2-28 rifles up to 5/8-24 thread pitch, so you may use 7.62mm suppressors in subcaliber role on AR15 and other 5.56mm rifles. Steel construction with sturdy wrench flats, in a dark gunblued finish. These are i

www.silencershop.com

 

[HingleMcCringleberry]

No.

 

[go4thegusto]

Do it all the time, no issues

 

[General RE LEE]

Zero issues and the can tightens my groups with my Howa Mini.

 

[The Fat Coyote]

I have one from brownells! No issues whatsoever!

 

[tikkashooter88]

Put one of these on my Tikka Roughtech Ranch 223 and no issues at all.

M4 Muzzle Thread Adapter

Engineered for 1/2-28 or 9/16-24 barrels. Easy install, perfect alignment, superior heat resistance.

precisionarmament.com

 

[atmat]

People will tell you it’s stacking tolerances and yada yada yada but it’s fine. Spend $15, glue it on, and be done with it.

 

[Marshfly]

I use these. You don't need anything fancy. Zero issues. I like that these are super low profile and don't add much length.

Amazon.com

 

[General RE LEE]

People will tell you it’s stacking tolerances and yada yada yada but it’s fine. Spend $15, glue it on, and be done with it.

You glue your adapter on? I just torque it down a little and it stays put.

 

[dreadi]

Sounds like you need a new suppressor.

 

[atmat]

You glue your adapter on? I just torque it down a little and it stays put.

I always rockset them on and torque to hell, yeah.

 

[HingleMcCringleberry]

I use rocksett and torque it to 30ish ft lbs to secure the thread adapter

 

[General RE LEE]

Has anyone take their can off and fired shots with just the adapter on? I tried it and got horrible accuracy. I was wondering why my gun was grouping so bad without the can until I realized the escaping gases were hittng threading and over hang.

 

[MTMeatHunter]

My rifle shoots significantly better 10 shot groups with the can on vs the bare adapter. I chalk it up to harmonics but I suppose it could be something to do with the bare adapter.

 

[General RE LEE]

My rifle shoots significantly better 10 shot groups with the can on vs the bare adapter. I chalk it up to harmonics but I suppose it could be something to do with the bare adapter.

The bare adapter extends beyond the muzzle crown by 1/8-1/4" with threading inside. I'm sure the escaping gases create turbulence. With the can on, the rifle is a shooter.