CodeMonkey
WKR
- Joined
- Feb 14, 2021
I think I have my tag plans in place.
I finalized my arrow build. If any of these software programs are to be believed, where I thought I was underspined, I've actually been slightly stiff. So my plans of cutting down the arrow and adding a good amount of weight all check out. I think someone needs to come out with a spine chart with assumptions other than 100 grain point and a standard insert.
I re-installed my side bar. I used to run it two years ago. Then last year I went off on a stabilizer tinkering crusade. I used a Quivalizer (which ended up being a crazy amount of front weight), but switched back to my old set up right before summer minus the side rod to cut down on mass weight. I ended up with too much float and my pins dropping out on me. I've only drawn and held on a small target in the basement, but so far the side rod is being welcomed back with open arms.
I finalized my arrow build. If any of these software programs are to be believed, where I thought I was underspined, I've actually been slightly stiff. So my plans of cutting down the arrow and adding a good amount of weight all check out. I think someone needs to come out with a spine chart with assumptions other than 100 grain point and a standard insert.
I re-installed my side bar. I used to run it two years ago. Then last year I went off on a stabilizer tinkering crusade. I used a Quivalizer (which ended up being a crazy amount of front weight), but switched back to my old set up right before summer minus the side rod to cut down on mass weight. I ended up with too much float and my pins dropping out on me. I've only drawn and held on a small target in the basement, but so far the side rod is being welcomed back with open arms.