I received one of the prototype suppressors to test out and give my feedback on. Figured I’d make a thread and post updates as I go.
I’ll primarily be using this on creedmoor based cartridges but will get some 6.5 prc through it as well.
My first impressions are very positive. I compared it to 3 other cans and plan on running it next to more as I go. It’s appreciably quieter than the other cans I had out. They were a JK Armament 155 configured to the same past the barrel length, PWS BDE556 in its longest configuration and a AB suppressors A10 30 cal.
I’ll try and get it next to a friends AB Raptor 8 because I think that would be a very good comparison. That can was my previous favorite for tone and suppression and I think this one will be as good in a shorter overall package.
I also really liked how the end cap didn’t have some silly design that made it impossible to get tape to seal over the hole.

I’ll primarily be using this on creedmoor based cartridges but will get some 6.5 prc through it as well.
My first impressions are very positive. I compared it to 3 other cans and plan on running it next to more as I go. It’s appreciably quieter than the other cans I had out. They were a JK Armament 155 configured to the same past the barrel length, PWS BDE556 in its longest configuration and a AB suppressors A10 30 cal.
I’ll try and get it next to a friends AB Raptor 8 because I think that would be a very good comparison. That can was my previous favorite for tone and suppression and I think this one will be as good in a shorter overall package.
I also really liked how the end cap didn’t have some silly design that made it impossible to get tape to seal over the hole.
