UM Tikka bolt handles

WyldGoose

FNG
Joined
Oct 16, 2022
Messages
53
Location
AZ
Did you guys Loctite your balls?
I used Rocksett on mine. Usually, a little goes a long way but there’s a good size cavity in the ball knob that it seemed to keep running into leaving the threads barely coated.
Third time was the charm and it’s on for good now.
 

Marbles

WKR
Classified Approved
Joined
May 16, 2020
Messages
4,362
Location
AK
Mine actually arrived last night. I initially used Rokset and heated the components, it did not set up well and broke free easily, so I switched to nail polish.

On both my Rokstok and the factory stock, the ball does not contact the stock and has about 1/16" of clearance.

I like the feel of this. It is an improvement over factory so far (I'll see if my opinion stays the same after more use). The MDT knob that goes over the factory handle was not, nor was an extended Lumley handle.
 
Top