Tuning speed for Iron Will Wide

[Eastonsgrandpa]

I have been a mechanical shooter for some time until the last while when some pain had me decide on 60 pounds over the 72-76 I was at.

I have two Arc 34 bows with 60 pound mods that pull 62 and 63 respectively.

I’m hitting 274-276 fps.

I have not started shooting broadheads yet and have bought standard and wide Iron Wills with solid blades on both.

Been hearing that sub 270 fps is much easier to tune them and since I have no experience doing so, I’m debating on getting 55 pound mods (pulling 57 and 58) and getting speed into the mid 260’s.

For those who have experience with these heads, do you agree on the speed and ease of tuning?

I’m much more concerned with a perfect flying arrow than one going a little faster.

Thanks.

 

[Mighty Mouse]

I doubt you'll have much trouble tuning those heads at speeds in the mid-270s. If you do have trouble, why not just back off the limb bolts a turn or two instead of swapping mods?

 

[Wapack]

You should be able to tune those no problem at 275. If you have to you can always use a bigger vane 4 fletched.