Truck topper question , who has a Tall topper

Last year I went full out trying to keep the dust out . Adhesive foam rubber around the tail gate and expanding foam in the sides of the bed .
It seemed to help but it was fourth rifle and the roads were covered in snow .
I put a diesel heater in it , cheap $100 , and with the windows open it was still too warm on the lowest setting.
Can you link the products you used?
You talking Home Depot spray can foam?
Thx
 
Re: fuel economy. I never drove my truck without the topper so can't compare before and after and I don't drive in a town/city but I get 19 -20 mpg in my '22 ram 3500 with an ARE MX unloaded.

I plan to drive this truck to its end, but if I don't I'll always have a tall topper, for all the reasons mentioned before.
 
Can you link the products you used?
You talking Home Depot spray can foam?
Thx
Yes , for the interior side of the bed where all the cutouts were I took cheap foam sponges to stuff in and around each hole to frame it , then used the large gap great stuff to seal it up .
Still there after a year .
This is the heater I used , it was chintzy looking but worked great .
I did substitute a marine gas tank instead of what they supplied but theirs would’ve worked fine.
I had a hole were a fifth wheel hitch was in the center of my bed so I mounted it there and covered it with the sleeping platform .
Ran the exhaust out the bottom one way and the intake the other .
IMG_3719.png
The control is the square thing and the round thing is where the heat comes out .
The heater is under the bed .

 
I made the frame so I could take it apart when I wasn’t camping , it’s stands up next to my freezer .
The green ratchet strap goes around the frame and “clamps” it to the side wall .
The plywood just lifts out for storage or to be stored.
The air mattress is cheap from Wallyworld but works great . Comes with a 12 v pump
JUST MAKE SURE TO DEFLATE IT WHEN YOU ATTAIN ALTITUDE , ask me how I know , 😂
 
Excellent thread, I just sold my topper and put a quad hard tonneau on my truck. Went back to a 9x12 tent and cot, 6'4" so getting in and out of my 3/4 ton was a pain. Ram bed height is crazy, you need a small ladder to get in without tearing up your shin's. The topper is great for hauling a ton of gear, but at 65 I'm down sizing all the gear I used to carry. If I need a bigger camp to go out of state I still have my 16" enclosed trailer.
 
Here are a few videos from YouTube that I suggest OP watch before he wades into the truck bed sealing effort - trust me, its a rabbit hole. I also highly suggest a mechanism to provide positive pressure to the canopy when driving on dusty roads. Even opening the front window of the canopy between the canopy and bed is a great idea.


 
Excellent thread, I just sold my topper and put a quad hard tonneau on my truck. Went back to a 9x12 tent and cot, 6'4" so getting in and out of my 3/4 ton was a pain. Ram bed height is crazy, you need a small ladder to get in without tearing up your shin's. The topper is great for hauling a ton of gear, but at 65 I'm down sizing all the gear I used to carry. If I need a bigger camp to go out of state I still have my 16" enclosed trailer.
I thought about a trailer but it would have to stored 10.5 months out of the year .
And my 3/4 is awkward to get in and out also .
 
My buddy has a bed rug. It seems legit and takes a lot of abuse.
They call it carpet, but I think it mite actually be a little more plastic then a fiber.

We toss bloody ducks and whatever in the back and it always seems fine
 
I have a mid height Leer 180 XR. I got the extra height for headroom when camping in it. I made a 16” tall bed platform. I can sit on that platform and my head just touches the roof. Makes it easier to get dressed and put on boots in the mornings. I made the platform as tall as I could without having to bend over when sitting on it. The taller platform allows me to fit larger bins under it. I lost at most 1 mpg after adding the cap. I think more like .5 mpg.

The carpet you linked looks like it would do a great job keeping dust out. I’ll still occasionally empty the back of mine and use it for “truck stuff”. Once in awhile I will spray the bed out with a hose to clean it. I didn’t want to permanently block areas allowing water to drain out of the bed. I use a Bedrug Impact mat for the floor. Tough surface over closed cell foam. Gives me a smooth surface and takes away all the pain of crawling around on your hands and knees. I stuff long strips of foam around the edges of it to keep dust from coming in where the bed floor meets the bed walls. I used a tailgate sealing kit and also strategically placing seals in gaps to seal the tailgate. Pics are before I sealed it.

1783547158254.jpeg
1783547210184.jpeg
1783547240283.jpeg
 
I did the tall topper for sleeping in the back of the truck for a few years. The extra height was definitely an advantage…..until your wife takes the truck to go shopping and tries to park in the underground lot! Lol
IMG-2177.jpg
IMG-2181.jpg
 
I have a leer 180 mid height also. I also have decked storage. I haven’t slept in it yet but plan to with a shorter cot. So far still fits everything I’ve needed to store in it. Need to look into this diesel heater thing…
 
I have a leer 180 mid height also. I also have decked storage. I haven’t slept in it yet but plan to with a shorter cot. So far still fits everything I’ve needed to store in it. Need to look into this diesel heater thing…
If I did the diesel heater again I’d make it a stand alone unit and bring it in through an outlet like this .

 
Back
Top