Tikka T3x Roughtech 6.5 PRC Range Report!!!!!!

[bow_hunt32]

Any need for a cheek riser? Just bought a roughtech 6.5 PRC.

I have Talley lightweight low rings with the 44mm objective and I feel it sits low enough that I dont feel the need for a cheek riser.

 

[TheViking]

Did you get the standard sporter barrel channel or the heavy channel?

You can request the D18 (Roughtech) barrel contour in our order notes. It arrived perfect!

 

[rrbailey]

Update #2! Took it out over the weekend and shot a 3 shot group at 415 yards (the furthest I can shoot on my farm) in a 10mph crosswind. Right at 3", Im starting to really like this gun and cartridge.

Very happy I stumbled upon your thread. Your roughtech 6.5 PRC is the exact rifle I have been researching! Are you still shooting with the factory barrel? Still using the the factory stock?

 

[Shortmag11]

You can request the D18 (Roughtech) barrel contour in our order notes. It arrived perfect!

How long did it take you to get the stock?

 

[TheViking]

How long did it take you to get the stock?

Within a week or two.

 

[bow_hunt32]

Very happy I stumbled upon your thread. Your roughtech 6.5 PRC is the exact rifle I have been researching! Are you still shooting with the factory barrel? Still using the the factory stock?

Good deal, this is why I love rokslide, Yes im still running the exact same setup. Its working too well to change anything at the moment!

 

[young7.3]

I bought the exact same rifle summer of 2023. Hornady 143 grain eldm ammo. Shot a mule deer at 50 yards and a bull at 300 yards in November 23. Both were dead in seconds. Love the rifle!

 

[swavescatter]

I love my Kalixteknik CR1 cheek riser. Doesn't need much rise with a Maven RS1.2 and UM lows. A touch heavier than kydex but gives it an OEM look/feel. High Desert installed it for free for me - great guy to work with.

I know this rifle would shoot better in a Rokstok but I love the Gucci-Ember look and feel. Kind of torn...

 

[sdupontjr]

I do wish the stock had a raised cheek piece - thinking of having a leather one made to tie onto the butt of the stock. Always seems like I have to pull my cheek up a bit.

While not a 6.5 PRC, I swapped my CTR 308 with a roughtech, sanded the barrel channel slightly for good fit. Then I installed a victor cheek riser that uses inserts to get the correct height.

 

[TAArrowood]

If you don’t mind my asking, how much did you have to sand out of the Roughtech stock to make it work? And what’s the setup weight after completion. I have a couple CTRs and a Roughtech and Veil stock. I’ve been thinking about doing the same thing.

 

[sdupontjr]

The only thing I couldn't get use to for my hunting situation was the CTR mag that stuck out the bottom. So in changing it out was a "need" for me. I only had to sand very little, however I like to free float my barrels. I also too some SS tubing and added pillars to it to help out. I picked up a plastic bottom metal and mag spring from Mountain tactical. I already had an additional mag from a 30-06, so it worked perfect. Modified my bolt stop, so now the CTR isn't limited to mag length of the standard 308.

Back to the pillars, I extended them to the same distance that the metal washer is recessed in the bottom metal. That was torquing wouldn't flex anything. I have T3 lite in 308 also that drives tacks, but this CTR is growing on me due to the shorter barrel in my tower stands.