Tikka rokstock fitment

[wind gypsy]

If you look at the barrel stamp relative to the stock on those stocks it looks like the one on the right covers more of the barrel stamp than the one on the left. Yet the bolt release inlet is the same. On my stock that barrel stamp is partially covered and the bolt release inlet is like yours. I’ve notice those variations on other pictures posted. I’m not griping about it as it seems like that is simply what we refer to as “ tolerances”. I also had to grind some material in front of the lug for my barrel and add shims under my bottom metal to get my magazine to function.

The picture is a bit deceiving because the guns are tilted at opposite angles and have different shadow effects but also i wouldn't look into barrel stamps much as these are aftermarket barrels of different contours with different markings. Even with factory barrels, i'm not sure they'd all be clocked exactly the same?

Far as I can tell visually, the action fits in both the same.

 

[Mtndawger]

The picture is a bit deceiving because the guns are tilted at opposite angles and have different shadow effects but also i wouldn't look into barrel stamps much as these are aftermarket barrels of different contours with different markings. Even with factory barrels, i'm not sure they'd all be clocked exactly the same?

Far as I can tell visually, the action fits in both the same.

Good point

 

[wind gypsy]

can you share a pic of the whole rifle of the one on the left plz? what to see the whole cerakote pattern I want to do something similar but black I think

 

[Dave Thomas]

Looking at it closer it seems that the recoil lug is sitting a little too high. Looks like the recoil lug bottoms out in action before action seats completely in stock but it also looks like the recoil lug is epoxied in so not sure if I can do anything with it without causing bigger issues. Sent an email to UM.

 

[HuntHarder]

Looking at it closer it seems that the recoil lug is sitting a little too high. Looks like the recoil lug bottoms out in action before action seats completely in stock but it also looks like the recoil lug is epoxied in so not sure if I can do anything with it without causing bigger issues. Sent an email to UM.

Are you able to measure how much the lug protrudes out of the stock? I'll be home shortly and can measure 1 of mine.

 

[NWBLKTAIL]

View attachment 1032345

What color is that top one?

 

[Dave Thomas]

Are you able to measure how much the lug protrudes out of the stock? I'll be home shortly and can measure 1 of mine.

The best I can measure with a set of calipers it's 0.120

 

[waspocrew]

Wasn't there/isn't there some "red carpet" QC where UM was checking fitment prior to sending out?

 

[mtnbound]

Can anyone post any pictures of a Tikka in a rokstock especially left side of action? I know the gas relief on left side of action in the factory stock sits right at the stock line. Mine sits a little higher in the rokstock. Can't seem to get action to fit down any deeper and not 100% sure if it's seating on the recoil lug.

Here are my 2.

 

[HuntHarder]

The best I can measure with a set of calipers it's 0.120

Using the bottom of my calipers, my brand new stock, the lug protrudes .095 measuring off the front of the lug and .085 off the rear.