Tikka 243 factory and 112 match burners

Joined
Feb 2, 2020
Messages
2,692
Is anyone getting the 112 match burner to shoot well out of a Tikka factory 8 twist 243 ?

I've only seen one report of them being tried and the result wasn't good. I have a 22" factory Tikka 243 on the way, so I'm wondering if it's worth trying them or not.
 

Benjblt

WKR
Joined
Dec 1, 2016
Messages
1,270
Location
Western Oregon
Is anyone getting the 112 match burner to shoot well out of a Tikka factory 8 twist 243 ?

I've only seen one report of them being tried and the result wasn't good. I have a 22" factory Tikka 243 on the way, so I'm wondering if it's worth trying them or not.
How'd this turn out for you? I was looking at the tikka superlite and noticed it had a 1:8 twist. Curious if a guy could get those long bullets to work in that chamber and magazine.. Like the 108 eldm or a heavier monometal bullet.
 

Marbles

WKR
Classified Approved
Joined
May 16, 2020
Messages
4,384
Location
AK
How'd this turn out for you? I was looking at the tikka superlite and noticed it had a 1:8 twist. Curious if a guy could get those long bullets to work in that chamber and magazine.. Like the 108 eldm or a heavier monometal bullet.
108 ELDMs are good. 112 MB were horrible, they stabilized (no key holes or baffle strike), but took me from nothing worse that 2 MOA accuracy to 10 MOAish. I'm willing to bet the OP is referencing this picture.

108 ELDM on the left, 112 MB on the right. I tried 2 powders and quite a few charge weights, they were more accurate at lower velocity for me.
20240630_073509.jpg
 
Top