Thread locker for Suppressor

[wildernessrimfab]

I use red locktite on the supressor end cap (direct mount) on nomad 30 Ti.
Also, a tiny dab of copper anti seize on the barrel threads.

Before the red locktite I had the supressor end cap unscrew from the nomad and stay on the barrel.

I can remove the can with my hands, I basically tighten it about 3/4 grunt and I have always been able to get it off without a wrench.

 

[Kurts86]

The TBAC guys specifically advise using Red Loctite 272 and not Rocksett so that's what I just got to put on a new CB brake. I just had to order it online.

Yeah I found this out the hard way when a CB brake carbon locked in my can and broke my 271 loose on a hunting trip. I called tbac and they went over it with me.

 

[WannaBeRambo]

Gonna take this in a new direction.
Have had SiCo Hybrid with DT bravo mount since 2016. Figured out teflon plumbers tape is the best.

You will want to experiment since as you add carbon from shooting you progressively need less.

The best practice in the case of threading the bravo mount to the barrel, only add tape to maybe 1-2mm threads closest to barrel shoulder. Don’t tape all the threads to barrel end.
You only need 2-4 turns of tape around the barrel shoulder area.
I only wipe the threads with an old Tshirt leaving a little residual oil, no need to get anal about removing all of it.

It doesn’t matter it shreds the tape as you thread the can, or that it bunches up. The idea is to gum upthe works just enough to lock it down while shooting, but not enough you have to ape it off when done.

Teflon plumbers tape won’t burn up or gum up anything a brass or stiff bristle brush can remove.

For the bravo to suppressor thread, I tape all the width of the threads. Since I never disassemble the hybrid, I will do 3-6 turns of tape around the threads. Easy way to do this is thread the bravo to the barrel (without tape), then thread the can to the bravo to get easy tool-less leverage.

Cheap, easy, works.

 

[Cosmono]

I just use red loctite.

 

[Geewhiz]

I just use red loctite.

Works until it gets hot.

 

[Marbles]

Loctite doesn't hold at high heat. Rockset does.

My adapters are rockset to my barrels, I have nickel anti seize on the threads between adapter and can and crank the can down as tight as I can by hand.

 

[wildernessrimfab]

Works until it gets hot.

I suppose it depends on the length of your shot strings. Ive had red loctite holding the front cap of my can on for 2+ yrs and its holding strong...then again I usually shoot max strings of 3-5 before cooling. My worry with rockset on the supressor cap was that it might hold too well!

 

[Lawnboi]

I suppose it depends on the length of your shot strings. Ive had red loctite holding the front cap of my can on for 2+ yrs and its holding strong...then again I usually shoot max strings of 3-5 before cooling. My worry with rockset on the supressor cap was that it might hold too well!

It’s only got to hold it till there’s enough carbon to hold it on there.

 

[wind gypsy]

It’s only got to hold it till there’s enough carbon to hold it on there.

Exactly. I've never used rokset or loctite on any muzzle devices. Crank shit tight enough and it seems to stay put long enough for carbon to do the rest. Long as you dont have reversed threads and have competing forces when things are going on/off, i dislike that.