The viper pst 2 failures

[Kidperfect]

I would like to hear from anyone who has had this scope and experienced a failure in it. Im currently shooting a rifle with this scope and i cant figure out my problem. If you’ve had one of these, please tell me what you experienced in the failure.

 

[rookieforever33]

I have had one on my 20 ga shotgun for about 150 shoulder stinging slugs. No failure yet. But I have had scopes that needed occasional readjustments that can only be explained by the scope zero wandering. I have also dealt with scopes that just didn't work well. It would be easier to help if you explain your failure as there are other links in the chain that could cause innacuracy. As in loose bolts/screws, cracked/uneven rings, or even shooting a load that will never be accurate. Always start with checking your entire mounting system. Then try another load in the rifle if you haven't. Depending on twist rates you may need to try different bullet weights. If no improvement you need to try a scope that has been proven. You can even borrow a friends scope if needed. If everything checks out with those steps and you verify that that pst is a pos send it back to Vortex.

 

[JohnJohnson]

I would like to hear from anyone who has had this scope and experienced a failure in it. Im currently shooting a rifle with this scope and i cant figure out my problem. If you’ve had one of these, please tell me what you experienced in the failure.

What exactly is the problem you're experiencing?

 

[dårlig jeger]

I had one that would lose parallax after a shot. You'd shoot a couple times then all of a sudden it was completely blurry.

 

[atmat]

This is know amongst Vortex scopes that they tend to lose zero

 

[Kidperfect]

What exactly is the problem you're experiencing?

I wish i had a better answer for that. Long story short, ammo has not changed. Rifle did not change, just the scope. Sight in went very well, and i was confident. First hunt, missed twice @250yds(chip shot). Back to the range after, cant hit paper. No drops, knocks or anything to bump it. It was mounted the way it should have been. I sent it to vortex, and they claim nothing wrong with it. The rifle shot groups with same ammo and different scope afterwards.

 

[Kyguy]

Did you remount and try again? What kind of rifle? I just went through this with a friend. He has a Remington 700 ADL in .223 that's a extremely accurate. Put a new scope on it and groups opened up. He took it all apart and reassembled, re-torqued, voila, it's grouping again. The internal mag box wasn't in the action correctly and causing pressure.