My PBB 22 creed barrel showed up 10 weeks after ordering. Lead time was projected at 10-12 weeks.
16", .120 FB, 1:7tw, 1/2x28 threads. 1lb 14oz.
It replaced a 243 barrel on a T3X. The action is about a year old. Removal sucked but I expected it. I couldn't get my barrel wrench to grab the barrel. Tried leather, rubber, etc. In the end it took a pipe wrench with a 3' cheater bar, a big steel hammer and 2 guys to turn the barrel threads. No corrosion once removed, just something that appeared to be thread sealant or anti-sieze. Absolutely ridiculous how tight it was. Scrapped the 243 barrel but that's fine.
Started with Alpha LRP brass, CCI 200 primer, 88 ELDMs and H4350. Worked from 38-40.5 without any bolt lift or ejector marks, primers were flatter as I increased. I settled on 39.5.
COL 2.716, 2.146 ogive.
First 10 round group was 1.18" at 100, 2862 fps average.
I switched to 4831sc. Was running out of case capacity at 43 grains and still 100fps slower so I parked that powder. Primers indicated less pressure than the H4350. Accuracy didn't seem significantly better in the 5 increasing loads I shot.
I also bought a box of Hornady Precision Hunter 80 eldx for science. I shot a 5 round group that was very close to the 88 eldm reloads. I didn't measure it on the target, just inspected through my scope. Average velocity was 2866.
I loaded 50 of 39.5 H4350 for now. Should have those burned up in the next week or 2.
All with the 75?And she eats again. Tagged out in Alabama, all with my 22CM. First year hunting with it and got a nice Muley in WY, a stomper of a whitetail in GA, and killed 3 WT bucks in my favorite part of our place in AL that requires waders and a backpack to get em out.
View attachment 829364
View attachment 829365
All with the 75?
Nice. I plan on trying that one next season. I've been using Berger 85.5 with good luckYes sir, plus 3 whitetail does in AL. None went more than 10 yards.