The 22 creedmoor thread

[Lawnboi]

Cleaned prior to antelope hunt. Going to use the Magnus…. Sounds and feels way better with it on. Otherwise same setup as the OP.

80eldx, went out to confirm 10 round zero.
2945 average with 80eldx.
400 rounds on the rifle at this point.

 

[Wrangler13]

Guys using h1000 are you using mag primers or regular?

 

[amassi]

Guys using h1000 are you using mag primers or regular?

Regular 210m


Sent from my iPhone using Tapatalk

 

[SouthPaw]

Guys using h1000 are you using mag primers or regular?

CCI450

 

[ACHILLES]

Guys using h1000 are you using mag primers or regular?

Fed 210 in LRP
CCI450 in SRP

 

[Duh]

Finally jumped and ordered a PVA 22 inch tube and had a local smith ream it. It was my wife’s Sigcross 6.5 creed. Hoping to shoot 62 vts for coyotes and 77 TMKs for everything else.

 

[dirtytough]

Threw a slow twist 22” barrel on a Tikka I wasn’t using. I got hard bolt lift earlier than I expected. Overall it shot well but it’s slow. Suppressed it with a 338 Ultra.

39 grains Varget
53 Vmax
Alpha 22 Creed SRP
CCI 450

3600 FPS.

 

[khuber84]

Threw a slow twist 22” barrel on a Tikka I wasn’t using. I got hard bolt lift earlier than I expected. Overall it shot well but it’s slow. Suppressed it with a 338 Ultra.

39 grains Varget
53 Vmax
Alpha 22 Creed SRP
CCI 450

3600 FPS.

New brass? Alpha ocd is kinda funky. To lean on it, you have to get a few firings on it with just a neck size and bump, or have a loose fitting die. The bottom side their brass is so tough it don't like to grip the chamber until it grows a bit. I had issues with some their brass until I figured that out.

 

[dirtytough]

Yes new Alpha brass. I will look into ordering a neck sizing die. Hopefully that will help. Thanks

 

[khuber84]

Yes new Alpha brass. I will look into ordering a neck sizing die. Hopefully that will help. Thanks

The Forster bushing bump die is what I've used for 3 firings before swapping to a FL bushing die.