SWFA zero stop shims

[pods8 (Rugged Stitching)]

Ok. If you still don’t have one after the cold bore challenge let me know and I can send you mine.

Sounds like two unmounted are offered so no need to break down yours.

 

[pods8 (Rugged Stitching)]

@limpet @Cdroot89 @Long Cut

I worked up a set off @Bluumoon scope (thanks!). His scope has 37.6mil of travel, the shim set will work if your zero point is ~28mil or less from the bottomed of adjustment. After that the brass disc in the turret rises above the housing so this arrangement won't be able to set a zero stop higher than that. You can put in ~28mil of shim as a bottom stop point and you have less than a full turret worth of elevation left so you can verify what revolution you are on one way or another but you won't be able to set a zero stop that is within .5mil like you can in the lower range. All that said if you're zero is that high in the travel of your scope I'd be looking at a MOA base or something because <10mils of travel isn't much.

I'll get some more sets made and add them to the classified listing.

 

[limpet]

@limpet @Cdroot89 @Long Cut

I worked up a set off @Bluumoon scope (thanks!). His scope has 37.6mil of travel, the shim set will work if your zero point is ~28mil or less from the bottomed of adjustment. After that the brass disc in the turret rises above the housing so this arrangement won't be able to set a zero stop higher than that. You can put in ~28mil of shim as a bottom stop point and you have less than a full turret worth of elevation left so you can verify what revolution you are on one way or another but you won't be able to set a zero stop that is within .5mil like you can in the lower range. All that said if you're zero is that high in the travel of your scope I'd be looking at a MOA base or something because <10mils of travel isn't much.

I'll get some more sets made and add them to the classified listing.

View attachment 1061839

Sweet. Thanks for making these for a discontinued scope. I have a 20 moa rail and it looks like my zero is one rev-ish from the bottom so it should work out.

 

[pods8 (Rugged Stitching)]

Sweet. Thanks for making these for a discontinued scope. I have a 20 moa rail and it looks like my zero is one rev-ish from the bottom so it should work out.

Yeah I wouldn't expect most folks to have a zero over 28mils (even without a MOA rail) but I wanted to clearly state the limitations that I discovered.