Stocky’s Hunter VG Tikka stock

[gman82001]

You can also get risers from Victor Company.

Is it common to need a riser on these stocks? One of the main reasons I ordered was because I thought it was going to help with the eye alignment

 

[Eleven]

I put just a small (less than a quarter inch thick) piece of sticky foam on one and it was perfect. No real cheek riser needed.

 

[bowrunner81]

Question for all you fellas out there with much more gunsmithing knowledge than I. Recently purchased this stock and it came without a recoil lug, so I picked up from Oregon Mountain Rifle.. this thing is snug and I’ve been wailing on it for about half hour now to get it seated. Stockys site says spec is .07” - .09”, but I have no way to measure that accurately. Is this lug too proud?

View attachment 973842

If it is seated all the way down then it should be good. If you set your barreled action down and torque it down, it should make marks on the flat area behind the recoil lug. If it doesn’t then it isn’t in deep enough. But, I just bedded mine and it fits way better. I would just do that, personally..

 

[CoMulies]

If it is seated all the way down then it should be good. If you set your barreled action down and torque it down, it should make marks on the flat area behind the recoil lug. If it doesn’t then it isn’t in deep enough. But, I just bedded mine and it fits way better. I would just do that, personally..

Can’t tell if it’s seated all the way honestly, had to use a small mallet to get it down. Everything seemed to torque down fine, guess I’ll see how it shoots.