Stocky’s Hunter VG Tikka stock

[TNHighlands]

Not sure if its been covered here. Are there any aftermarket recoil pads for the stocky's vg's?

Looking to put a superlite 7mag in one and the limbsaver definitely helps tame it a bit on the factory stock with vertical grip installed.

Hoping the stock will be more rigid and the recoil pad would be a cherry on top.

Thanks in advance for any insight.

 

[Harvey_NW]

Not sure if its been covered here. Are there any aftermarket recoil pads for the stocky's vg's?

Looking to put a superlite 7mag in one and the limbsaver definitely helps tame it a bit on the factory stock with vertical grip installed.

Hoping the stock will be more rigid and the recoil pad would be a cherry on top.

Thanks in advance for any insight.

The Stocky's come with the thin limbsaver so I think the airtech style is direct replacement. I like the airtech as well and think they make a noticeable difference.

 

[NWBLKTAIL]

The Stocky's come with the thin limbsaver so I think the airtech style is direct replacement. I like the airtech as well and think they make a noticeable difference.

I second the airtech style it’s makes a noticeable difference, usually one of the first things I snag

 

[TNHighlands]

The Stocky's come with the thin limbsaver so I think the airtech style is direct replacement. I like the airtech as well and think they make a noticeable difference.

I second the airtech style it’s makes a noticeable difference, usually one of the first things I snag

Thank you both! Just wanted to confirm as i'm as fond of them as you are.

 

[Harvey_NW]

Thank you both! Just wanted to confirm as i'm as fond of them as you are.

I'm not 100% certain the part number for Tikka is the exact fit on the Stocky's, but I just compared a factory stock with Airtech to Stocky's with the slim and they look similar. I can tell you and take pics tomorrow evening, as that's where it was going to end up anyway.

 

[Winternews]

I just went to Cabela’s with the stock recoil pad, which is 5 1/8” long by 1 3/16” wide. The Tikka-compatible limbsaver pad was too short— it did not reach all the way down to the bottom (toe?) of the stock. All the other limbsaver pads they had were also too short (700, etc).

Does anyone know if there is a compatible bolt on pad?

On a T1x I used a piece of plywood cut as a spacer but would prefer a readymade option.

 

[mxgsfmdpx]

I just went to Cabela’s with the stock recoil pad, which is 5 1/8” long by 1 3/16” wide. The Tikka limbsaver pad was too short. All the other limbsaver pads they had were also too short (700, etc). I need to increase LOP on my stock so I am looking for a thick recoil pad. Any suggestions?

On a T1x I used a piece of plywood cut as a spacer but would prefer a readymade option.

Give this a go...

Stocky’s Hunter VG Tikka stock

Yes. It’s been added to the list for 2024 Put me down for two of them!

rokslide.com