Excellent shooting!
Show your Tikka ten round groups
- Thread starter HighUintas
- Start date
Have you got to play around with testing zero retention on that WTO system? I’m guessing zero retention when swapping the same barrel on/off/back on again doesn’t happen, but more thinking about it from a light drop testing perspective. I’ve never really looked into them seriously but the concept is cool, curious if it’s one of those things where the added feature also means added baby sitting, to a certain degree?
david2duck
WKR
@walk2112
I haven’t had the rifle long enough to speak on much of anything. Once I have both barrels locked in with load development I’ll be able to play around with it more. I did take the 6cm barrel on and off a few times and tested whether or not it held zero. A small sample size but it looks good so far.
I haven’t had the rifle long enough to speak on much of anything. Once I have both barrels locked in with load development I’ll be able to play around with it more. I did take the 6cm barrel on and off a few times and tested whether or not it held zero. A small sample size but it looks good so far.
Very cool. Thanks for response. They claim it’ll return within 1/2 moa when reinstalling the barrel, that’s pretty darn good
Jimbee
WKR
- Joined
- Mar 16, 2020
- Messages
- 1,072
I don't always shoot good groups but when I do I post them on Rokslide
CSHunter802
FNG
Tikka 7mm RM, factory veil wideland.
160gr accubond, 70gr h1000, peterson brass, rem 9.5M primers.
Just under 1.2"
First ever 10 round group of my own loads. I've only shot load development w/ varying charges up to this point as I start my reloading journey. Found the speed I was looking for with this bullet/powder combo and no pressure so I loaded 10 up and this is what I got.
160gr accubond, 70gr h1000, peterson brass, rem 9.5M primers.
Just under 1.2"
First ever 10 round group of my own loads. I've only shot load development w/ varying charges up to this point as I start my reloading journey. Found the speed I was looking for with this bullet/powder combo and no pressure so I loaded 10 up and this is what I got.
That's a great group out of a magnum, good shooting!
CSHunter802
FNG
Thanks Harvey! I believe it was your suggestion a few months back to give H1000 a shot with the 160s. Certainly worked out for me
That's funny, that is a load I have suggested a couple times. Glad it worked for ya!
Extensive group testing session today with a variety of 6.5cm ammo in my NRL hunter rifle (bravo d18 rs1.2)
Each group was 10 rounds, fired as fast as I could run down to 100 yards and mark. Groups did open over time, though this may have more to do with mirage off the Scythe ti than system heat more broadly.
Didn't expect this cheap Winchester Deer season to put up such a tight group:
140 SMK did predictably well:
140 ELD-M in 1.1":
143 ELD-X struggled a bit:
147 ELD-M shot just under an inch:
A while ago I bought a big stash of Norma Golden Target, a .635 G1 143 grain match load. I'm generally able to get sub-minute groups out of it, so I think the mirage or system heat was starting to overwhelm me here. Still not the disaster like most hunters would expect after 50 rounds in half an hour:
Let's finish off with a group from my .223 in a hogged out factory stock, which was 10% bigger than the groups it was shooting in my Alterra or Wildcat:
None of this is data (yet), and I'm happy with all of these groups. Hope it's helpful to someone.
-J
Each group was 10 rounds, fired as fast as I could run down to 100 yards and mark. Groups did open over time, though this may have more to do with mirage off the Scythe ti than system heat more broadly.
Didn't expect this cheap Winchester Deer season to put up such a tight group:
140 SMK did predictably well:
140 ELD-M in 1.1":
143 ELD-X struggled a bit:
147 ELD-M shot just under an inch:
A while ago I bought a big stash of Norma Golden Target, a .635 G1 143 grain match load. I'm generally able to get sub-minute groups out of it, so I think the mirage or system heat was starting to overwhelm me here. Still not the disaster like most hunters would expect after 50 rounds in half an hour:
Let's finish off with a group from my .223 in a hogged out factory stock, which was 10% bigger than the groups it was shooting in my Alterra or Wildcat:
None of this is data (yet), and I'm happy with all of these groups. Hope it's helpful to someone.
-J
wind gypsy
WKR
- Joined
- Dec 30, 2014
- Messages
- 9,508
Internet post: “Varget shoots 0.11” MOA tighter than 4350 in my rifle”
Nice shooting.
Last edited:
Haven’t checked speed. That’ll be the deciding factor.
Bowfinn
FNG
Tikka 6.5 PRC - chamber cleaned up with AW2 reamer, throated for 140's, and chopped to the flutes. Ran up to 59gr N565 today with no signs but hit 3k fps so I think she was a bit spicy, loaded 10 at 58 and sent em prone off a new Spartan bipod. Happy as can be!
As promised, the 6.5cm Tikka really does love Norma Golden Target. Similar group produced by Dan's rifle today (both in Bravos - 1 a lite, 1 a veil).
It also loves Berger 140s
But has a somewhat more complicated relationship (still) with Frontier 68 BTHP. I still have yet to try the 75 Frontier stuff, but I'm curious.
Best,
-J
It also loves Berger 140s
But has a somewhat more complicated relationship (still) with Frontier 68 BTHP. I still have yet to try the 75 Frontier stuff, but I'm curious.
Best,
-J
Similar threads
Featured Video
Stats
Latest Articles
-
Kryptek Traverse Merino Review
-
First Lite 308 Pant Review
-
Argali Selway 6P Tent Review
-
AGC Kobuk 2800 Backpack Review
-
Hunting The Leaf-off Window
-
TT#41 Jordan Budd’s Tips on Finding and Killing the Big One
-
NEMO Hornet Elite Osmo 1P Tent Review
-
Rokcast Reload: Stories from a Wall Tent
-
Vote No On Prop. 127
-
Marlon Holden: High Level Mule Deer Stalking