Short barrels

[cbynum80]

has anyone played around with a 6.5 prc or 6.5 rpm with 18” barrel or something similar?

 

[justinspicher]

Wouldn’t that make it a creedmor?

 

[cbynum80]

I would think a little faster than a cm but shorter and a suppressor

 

[MuleyFever]

O

Thread '6.5 PRC/SAUM shortest barrel length'

Dec 24, 2024

Current build is a 6.5PRC or SAUM built with the following:

ARC CDG short action
TT primary
MDT HNT26 folder
Atlas Bipod
ATACR 7-35 (MOA for all you haters)
TBAC Ultra 9 (compensating for something)
H1000
Hornady 143gr ELD-X
Hornady once fired brass (will probably buy Lapua)

I’m not settled on barrel length yet. I’ve seen some run down to 18” with good performance. Looking for some of you guys with experience in your builds. I’d like to shoot out to a mile. Shoot coyotes out to 1000. Shoot deer and elk out to 800.

• Oklahoma33
• Replies: 52
• Forum: Long Range Hunting

• 

N

Thread '18" 6.5 PRC Real world data and velocity.'

Feb 2, 2025

I am currently working on load dev for a Tikka Veil wideland (cut to 18" and threaded by class 3 machine before he passed). I initially began load work with the 135 A tip as I had a few hundred and H4831SC and that seemed to be the recommended powder for short PRCs. Results have been relatively disappointing so far compared to what I have read.

This rifle has roughly 90 rounds on it, so the barrel may speed up still, I just have not personally seen Tikka barrels speed up much in the past.

All load dev currently has been done with new peterson brass, and federal LRP (non magnum).

53...

• Njadams13
• Replies: 5
• Forum: Reloading

Thread '6.5 PRC velocity and barrel length?'

Dec 8, 2019

Just curious what people are seeing for real world speeds.

What brand gun or barrel?
What bullet and powder or factory load?
Barrel length?

Thanks. I'm interested in getting one but want to see how much real world speed I gain over the 6.5 Creedmoor.

• mcseal2
• Replies: 54
• Forum: Firearms