Sauer 100 6.5 Creed review

[Q_Sertorius]

I will report back after I receive it and shoot it. By the way, would you remind me of the recommended torque values for the stock screws? I know that was posted here somewhere…and I recall that the values are different for the front screw as opposed to the rear screw.

It’s post #15 in this thread.

 

[Tonopah]

Thank you

 

[vonb]

I will report back after I receive it and shoot it. By the way, would you remind me of the recommended torque values for the stock screws? I know that was posted here somewhere…and I recall that the values are different for the front screw as opposed to the rear screw.

Per Blaser Group in an email to me:

S100 torque specs:

Front nut under the floor plate 44 inch/lb

2x Floor plate bolt 35 inch/lb

Stock = hand tight