Finished up thread protector for a Rokslide barrel this evening!
Sent from my iPhone using Tapatalk
Are those orange warning cones.Well I only have around 30 rounds down the barrel thus far, but I must say I am pretty impressed. Mike did a bang up job putting the barrel on.
There is enough carbon here to go around:
I will say after barrel break in I loaded up 9 cases each in .5 grain increments and the rifle managed to keep all 9 inside just over an inch which is pretty good for spanning 4 full grains of powder from the lightest to the heaviest charge.
And while we were at it we also tested to see how big of a discrepancy between LabRadars there was.
7.5 lbs in the dot. Not pad considering your stock is the sporter fill
Mike
Sent from my iPhone using Tapatalk
Not bad at all, basically the weight of a CTR tikka yet with 4" more barrel with a brake and also a heavier stock. An edge fill stock would get that down to ~7lb but that wasn't worth worrying about versus the price I got that stock at, it wasn't intended to be an ultralight. Scoped out 8.5lb vs 9lb doesn't matter much to me. It'll be a stable shooter.
Are those orange warning cones.
