Ram 2500 Tire Chains

[go_deep]

Help me understand your point of view, but as I see it this would not give the best possible traction to 4WD vehicles with open diffs.

I envision this setup running into problems with cross axle traction loss - fairly common to encounter when offroading and suspension flexes out. Opposite side / opposite corners tires lose traction and spin, and you’re stuck.

I have so far found it to be true that power follows the path of least resistance in open diffs. Tires with no traction (resistance) spin.

I envision that keeping one axle chained on both sides is better. Both tires will offer similar resistance (and therefore receive similar power) up until you flex out the suspension pretty extremely and one tire is in the air or nearly in the air.

If you place them on opposite sides and opposite corners, aren’t you:

1. Making it less likely that each tire receives similar power, and therefore experiencing wheel spin more frequently

2. Gambling on the fact that you might encounter a situation where you flex out the vehicle and both of your “naked” tires are hanging in the air/loose snow? Now you have to get traction boards or build up a surface to get a “naked” tire to grip? Or swap chains to that tire? If I only chain up my front or rear axle and get stuck, I must build up snow/dirt or get a chained up tire to catch on a traction board. That seems preferable to me.

Can't give you anything scientific other than I work for a utility company, we use chains a lot, and thats what we were instructed to do, and it works great to keep your truck running straight, especially on any kind of a road with a slope.

 

[chizelhead]

I've used a few types. I prefer Lacelde Alpine Super Sports chains with the diamond pattern. They don't feel like you are on a washboard road and they are easy to put on. I have two sets for all four wheels. If you can find a Les Schwab, you can buy the Laclede chains and return them if you don't use them. Call ahead to make sure they have what you want when you go to pick them up.

 

[WiscoHoundsman]

I have a 2015 ram 3500 with 275/70/R18 and have used chains all the way around without issues but I’m going 6-8 mph when I’m chained up. I have the studded and v bar chains from here: https://bluejayindustrial.com/traction-tire-chains/light-trucksuv-chains
The cams work great, take some wire or zip ties to tie up any loose chain.

 

[mt terry d]

Why do you have open diffs?

Only vehicle I ever had with a locking differential ( other than a semi) was an old 2 wd International.
Man, that thing could get me stuck in places a 4wd couldn't hardly get to.

Long handled tire chain tool makes it easy to build/fix your own sets.

I've modified chain sets before but haven't heard of this tool.
I'll look into this, but I'd really like to have the cam tightening system.

 

[Choupique]

have used chains all the way around without issues but I’m going 6-8 mph when I’m chained up.

That's the only thing I dont like about the v bar chains. The traction is amazing but over 10mph its like driving a truck with square tires unless there is A LOT of snow. Driving it on gravel, woof. Awful.

Idk if I've ever gotten back from somewhere with them that regular chains wouldn't have to be honest. I think they're really more well suited to log trucks than a pickup.

But damn do they ever look cool and inspire tremendous confidence for a stupid southeastern flatlander who has no business driving in snow or mountains, much less both at the same time.

 

[mt terry d]

Thanks. I'll check with YouTube University for directions on how to use it.

 

[Wrench]

Locked axles and ice with a tiny bit of slope is how you lose your rig. Open diffs keep one tire planted. Opposing corners will keep you from sliding off a slope, but will not provide the best power distribution. 4 chains is the ticket.

Some guys chain the front, some the back....but really, having a brain and not screwing around on off cambers is the win. If it's an off camber turn, pack your speed and stay high.....if you slide, dont do anything quick.....just be smooth. Smooth is key.

 

[mt terry d]

And remember to tell your buddy
"Hold my beer!"

 

[260284]

I run v-bar chains if things are going to be icy and heavy lug chains the rest of the time. 3/4 ton dodge diesel here as well. Stay away from the smaller light duty chains, they won't hold up

What year is your truck and what tire size?

 

[260284]

I bought these self adjusting AutoTrac / Peerless chains for a snow wheeling trip a few winters ago. I ran them on all 4 tires. They worked as advertised and everyone else was impressed by how easy they were to set up. I followed some much better equipped rigs and was able to hold my own.

My understanding, though, is that the self-tightening equipment on the sides of the chain is a potential point of failure - don’t smash that on a rock.

Beyond that, the bag is nice and sometimes I put these in the bag and then in my pack for rucking.

What truck did you run them on?

 

[getcervid]

What truck did you run them on?

My 2001 Toyota Tundra 4x4.

 

[jtevanMT]

I use a set of 4 v-bar chains, with cam-locks and snubbers to take up any slack. Most of the time I only use 2 (on the front) and occasionally chain all 4 if the roads are really bad. Always pack a shovel when traveling mountain roads in the fall/winter.

 

[mt terry d]

Here's something to consider.
The only two times I've almost run off a slippery snowy mountain road was when
I tried going uphill in 4WD without chaining and didn't make it.
Figured it was worth a try. Going to back down and chain up and the F***ing
ABS kicks in and bop-bop-bop-bop-bop-bop and I'm gaining speed right quick.
Luckily it was a straight shot to the level.

Now when it's at all sketchy I pull the fuse to the ABS. Works like it should, the
light just comes on. If I could figure out how to shut off the light I'd leave the
fuse out all the time.
Would love 5 minutes with the guy who made ABS mandatory.

 

[260284]

Here's something to consider.
The only two times I've almost run off a slippery snowy mountain road was when
I tried going uphill in 4WD without chaining and didn't make it.
Figured it was worth a try. Going to back down and chain up and the F***ing
ABS kicks in and bop-bop-bop-bop-bop-bop and I'm gaining speed right quick.
Luckily it was a straight shot to the level.

Now when it's at all sketchy I pull the fuse to the ABS. Works like it should, the
light just comes on. If I could figure out how to shut off the light I'd leave the
fuse out all the time.
Would love 5 minutes with the guy who made ABD mandatory.

I can shut off my traction control and it doesn't give me any problems.

 

[doc holiday13]

I have a 2015 ram 3500 with 275/70/R18 and have used chains all the way around without issues but I’m going 6-8 mph when I’m chained up. I have the studded and v bar chains from here: https://bluejayindustrial.com/traction-tire-chains/light-trucksuv-chains
The cams work great, take some wire or zip ties to tie up any loose chain.

Thanks for that link

 

[doc holiday13]

Here's something to consider.
The only two times I've almost run off a slippery snowy mountain road was when
I tried going uphill in 4WD without chaining and didn't make it.
Figured it was worth a try. Going to back down and chain up and the F***ing
ABS kicks in and bop-bop-bop-bop-bop-bop and I'm gaining speed right quick.
Luckily it was a straight shot to the level.

Now when it's at all sketchy I pull the fuse to the ABS. Works like it should, the
light just comes on. If I could figure out how to shut off the light I'd leave the
fuse out all the time.
Would love 5 minutes with the guy who made ABD mandatory.

Traction control has gotten me stuck more than its prevented me from sliding off the road. Its happened enough that every time I put 4wd on, I turn off traction control and the other ABS system.

 

[WiscoHoundsman]

Thanks for that link

If you order some play around with what’s in your cart to get better shipping prices. I just checked and a set of chains is crazy expensive but if you add in the bungee adjusters it’s gets reasonable went from something like $150 to $30 for my address.
It’s silly and maybe calling will get a better shipping price. A few years ago I was told that’s just how it is so I ordered the cheapest thing I could add to the cart with chains to get the best shipping prices.

 

[doc holiday13]

If you order some play around with what’s in your cart to get better shipping prices. I just checked and a set of chains is crazy expensive but if you add in the bungee adjusters it’s gets reasonable went from something like $150 to $30 for my address.
It’s silly and maybe calling will get a better shipping price. A few years ago I was told that’s just how it is so I ordered the cheapest thing I could add to the cart with chains to get the best shipping prices.

WTF.. hahahaha thanks for the tip. A lot of money for chains. Those are beefy chains too. I can't see going over 10mph in those

 

[Extrapale]

Here's something to consider.
The only two times I've almost run off a slippery snowy mountain road was when
I tried going uphill in 4WD without chaining and didn't make it.
Figured it was worth a try. Going to back down and chain up and the F***ing
ABS kicks in and bop-bop-bop-bop-bop-bop and I'm gaining speed right quick.
Luckily it was a straight shot to the level.

Now when it's at all sketchy I pull the fuse to the ABS. Works like it should, the
light just comes on. If I could figure out how to shut off the light I'd leave the
fuse out all the time.
Would love 5 minutes with the guy who made ABS mandatory.

If you have a Ram, check out Abel Components. He makes a bypass switch for ABS. Same as pulling the fuse, just more convenient.

 

[IDVortex]

So far good advise. Ill 2nd, 3rd? Of get chains one can rebuild, including having the chain tool.

Make sure you carry links, and extra crossovers, a couple cams aswell.

If you're not comfortable, chain up, you do not want to chain up after you allowed your ego to control your decision.

Make sure you have parts, and once something breaks, if you can fix it, fix it. Its all fun and games until you have a crossover break, and instead of fixing it, you say yolo and now you get to change a tire due to it being stabbed into the tire. Ask me how I know.

Carry extra bungees, even with spider bungees, if you cant get the chains tight. Use bungees too. Keep your chains tight, you'll break something.

I second buying used truck chains and making them your own size, call up your local road department, see if they have any bad chains you can cut down.

Oh, have all parts you may need for breaking chains. Think of everything, and make sure you have the stuff. Even if you dont use it, it's a piece of mind. Especially if you've never used chains.

Watch some videos of how to get unstuck with chains, or how to get them on when you're in a bad situation.

And when you're cussing yourself out, the trip, the truck when you get stuck, just be grateful your not at home wishing you were in the mountains.