- Thread Starter
- #21
- Joined
- Oct 22, 2014
- Messages
- 10,287
Is that normal for a fixed parallax scope?
Pretty normal- from one edge to the other .5”.
Am I getting this correct? During the rtz eval it worked one time then the second time it stuck until you pulled the turret and reset. Then it worked one more time and then stuck again? That ring was coming out of the groove and causing the bind?
No, it dialed up and down approx 200 mils, then a shot, then dial up and down, 200 mils, a shot, etc. On the fourth shot it skipped a rev and locked up on the second rev- that is after dialing up 19 mils, when dialing back down it somehow skipped the rev ring and stopped at halfway back down (one full rev to high). Reset, then it did it again on round 6 (IIRC), reset it, then it worked fine.