Progressive setup for 300BO advice needed

Team4LongGun

Super Moderator
Staff member
Joined
Aug 4, 2019
Messages
2,318
Location
NW MT
Looking to reload for 300 BO, large quantities. What is the best setup that doesn't need constant tinkering? I have only ever loaded precision handloads, single stage press, advice appreciated.
 
That's a loaded question. Do you already have brass or are you going to be forming from 223/5.56? If you are going to be forming, I would be looking at a bigger Dillon with the ability to process cases in volume. At least a 750, if not an 1100. I would add a case feeder. Bullet feeders and electric or hydraulic driven if you want big volume and more painless other than cost. If you have brass or going to source externally, than you can use the more versatile 550. Once you get one of these set up, shouldn't be a lot of tinkering. I sourced a bunch of brass years ago in the 10 to 15 cents a piece range. Not sure what the going rate. Mine was fully processed and roll sized and ready to load.
 
How much is a large quantity?

I have a dillon 550 that I use for higher volume bolt gun stuff. If I wanted to load for significant AR use where a guy is shooting multiple hundred rounds a range trip id want at least a 650/750 with bullet and case feeder.

I'm not as familiar with other brands of progressives.
 
I have been using a Lee for my 300 Ham'r , works good for what I need. I process all the brass first then just load them up. Easy to do a couple hundred rounds an hour if your arm can handle it. :sneaky:
 
I load 300 B.O. for a comp gun on Hornady AP. I have loaded 10k rounds on this press. I use Starline brass mostly, and some 5.56 L.C. that I bought processed. I can load about 400 rounds per hour using the AP's powder measure. I don't have a case or bullet feeder.
All that said a Dillon is a step up from the Hornady, and case & bullet feeders will increase output. Just depends how much ammo you want and how much you want to spend. I got my Hornady 10 years ago for $200 at a store that was going out of business.
 
Back
Top