New Powder Thrower

[Judd]

I'll give you $100 more than gypsy and Matt

totally kidding but funny!

 

[Tahoe1305]

Dibs.

I don’t think that style of trickler is going to play nice with ball powder..

Why do you say “that style of trickler” won’t work with ball? I’ve watched some videos and can’t figure out why it wouldn’t.

 

[wind gypsy]

Why do you say “that style of trickler” won’t work with ball? I’ve watched some videos and can’t figure out why it wouldn’t.

Isn’t it a disk like the ingenuity? Just seems like something that is made to play nice with extruded kernels but struggle with the finer ball powders.

 

[Tahoe1305]

Isn’t it a disk like the ingenuity? Just seems like something that is made to play nice with extruded kernels but struggle with the finer ball powders.

Maybe I don’t understand a type of trickler other than a spinning tube…..I’ll do some more research.

I watched a video that compared the super trickler to a V4 for time loading 50
cases. Both were about 17min if I recall (super 30 seconds faster I think).

I use two older RCBS lites that actually do a good job (verified with FX120). Then I got a dandy trickler and a controller that runs that to within .02g. I was able to replicate 50 loads within a minute of those two units and I think more precisely too. I figure with my 200-300 rounds a year I’m probably ok.

 

[wind gypsy]

Maybe I don’t understand a type of trickler other than a spinning tube…..I’ll do some more research.

I watched a video that compared the super trickler to a V4 for time loading 50
cases. Both were about 17min if I recall (super 30 seconds faster I think).

I use two older RCBS lites that actually do a good job (verified with FX120). Then I got a dandy trickler and a controller that runs that to within .02g. I was able to replicate 50 loads within a minute of those two units and I think more precisely too. I figure with my 200-300 rounds a year I’m probably ok.

It comes with multiple disks with different tooth sizes for different sized stick powders. Those little teeth control release of the individual kernels more precisely than a spinning tube but dont play well with ball/flake powder.

I'm currently using the AT v3 that has a more traditional spinning tube for trickling functions. Works well, this disc setup appeals for having fewer overthrows, being a c-hair faster, and hopefully requires less calibration.