My Tikka groups suck

[philcox]

I believe I have more than enough clearance. Same on both sides and increases as barrel tapers

Sent from my iPhone using Tapatalk

 

[ResearchinStuff]

That kind of looks like it's not seated right on the recoil lug

 

[mxgsfmdpx]

I believe I have more than enough clearance. Same on both sides and increases as barrel tapers

Sent from my iPhone using Tapatalk

Can you send the same photo but zoomed out a bit please, to see the entire stock?

 

[wind gypsy]

Is the 73 ELDM Hornady Factory "good enough"? Is there anything that is "good enough" but not quite as $$

factory 73 ELDm shot as good as anything in my factory tube. ADI 55 SBK is usually pretty solid too for less money.

 

[philcox]

I took the action off and reset it and torque it down to 55 inch pounds. These are the pictures after that.

Sent from my iPhone using Tapatalk

 

[ResearchinStuff]

That looks gtg to me

 

[philcox]

That looks gtg to me

Yep, when you mentioned it, I think it was slightly “on” the recoil lug. I made sure the lug was “in” the slot all the way this time.


Sent from my iPhone using Tapatalk

 

[ResearchinStuff]

If it was out of place when you were shooting, that was definitely adding to your dispersion.

 

[philcox]

If it was out of place when you were shooting, that was definitely adding to your dispersion.

It was.

 

[ResearchinStuff]

Take some handloads with you to the range too.

 

[Claybuster]

I always look for this hole alignment when reassembling the action into the stock.

 

[philcox]

Take some handloads with you to the range too.

Yep, going to take my HL 140 ELDM, 130 TMK, and my 124 Hammer Hunters (known decent in this rifle) and see how they compare to the Factory 140 ELDM. I need to buy more DRT projectiles to see if they work