Minox ZP5 5-25x56 MR4

[Formidilosus]

Did you happen to check on this?

They are the 1.00” versions. It could go lower.

 

[Dobermann]

I just want to know the gap you have, then I can reverse math because I have a pic rail, and I a little more figuring swapping a Tikka profile and my heaviest barrel.

Your 1.3 makes me believe I can do a 1.1X medium instead of a 1.2X high from ARC or Area419

Seeing as you're going to test the DFND fishnet baselayers for us ...

The gap between the bell and highest part of the barrel (ie smallest gap) is approximately 7-8 mm. Note the 'approximately' - my calipers aren't handy, so I just used a stack of business cards until I had a snug fit and measured the height of those. So there's possibly +/- 1 mm in that range ...

I hope that's somewhat helpful!

 

[sndmn11]

Seeing as you're going to test the DFND fishnet baselayers for us ...

The gap between the bell and highest part of the barrel (ie smallest gap) is approximately 7-8 mm. Note the 'approximately' - my calipers aren't handy, so I just used a stack of business cards until I had a snug fit and measured the height of those. So there's possibly +/- 1 mm in that range ...

I hope that's somewhat helpful!

Thank you