Magazine set screw.

[Badlandoutdoors]

Question for those with much more experience than me(most of you). My rifle is dropping the mag when firing a shot. I contacted the manufacturer and I need to tighten the magazine release screw. To do this I need to remove the action screws, pull the action and tighten the screw 1/2-1 full turn. Then reassemble. The video looks simple enough.

My question. Is it really that easy or is there something I need to pay attention to so I don’t screw up the rifle?


Sent from my iPhone using Tapatalk

 

[pods8 (Rugged Stitching)]

What rifle?

In regards to the action screws, clean/decrease, loctite/paint pen them when reinstalling and properly torque them to specs.

 

[Badlandoutdoors]

What rifle?

In regards to the action screws, clean/decrease, loctite/paint pen them when reinstalling and properly torque them to specs.

Horizon vandal prime.

For the loctite, red or blue?


Sent from my iPhone using Tapatalk

 

[pods8 (Rugged Stitching)]

For the loctite, red or blue?

Blue for action screws if using loctite (many here use paint pen) since you want to reasonably be able to remove them again (red may require heat to remove).