Lift x 33 review

[TaylerW]

Recently acquired a new lift x 33. Specs are 28”dl, and 76 lb with the 75lb mod. Initial impression was stellar. Draw cycle from start to finish is leaps and bounds better than my last bow, a v3x with similar spec. I love how stout the wall is. Transition in and out of the valley is super pleasant. Hold weight about 15lb. At the shot it’s totally dead in the hand. Tuning was so simple. The limb shift isn’t just jewelry. Most surprising was how much faster it is. Haven’t gotten chrono on it, but I jumped 3 sight tapes (spot Hogg). Probably have about 300 shots in so far. Will update once broadhead league starts.

 

[Ho5tile1]

Yeah I love my Lift X 29.5 it’s for sure a shooter I also use a spot hogg boonie with a ultraview scope… congrats on a fine bow


Sent from my iPhone using Tapatalk

 

[sndmn11]

Recently acquired a new lift x 33. Specs are 28”dl, and 76 lb with the 75lb mod. Initial impression was stellar. Draw cycle from start to finish is leaps and bounds better than my last bow, a v3x with similar spec. I love how stout the wall is. Transition in and out of the valley is super pleasant. Hold weight about 15lb. At the shot it’s totally dead in the hand. Tuning was so simple. The limb shift isn’t just jewelry. Most surprising was how much faster it is. Haven’t gotten chrono on it, but I jumped 3 sight tapes (spot Hogg). Probably have about 300 shots in so far. Will update once broadhead league starts.

Can you, or anyone who sees this, turn your limbs down the 2 turns max, and take a picture from the side of the limb pocket?

I posted this on archerytalk but for no response. I got a LiftX33 so I can shoot through shoulder recovery. It hasn't been shot. When I take two turns out, the washer bezel on the bottom limb ends up hanging past the target side edge of the limbs. I am curious if this is normal.

Full tight


Two turns out

 

[TaylerW]

I would normally be happy to help, but my bow is dialed and I’m not looking to mess that up any time soon lol. Good luck on your quest.

 

[Ho5tile1]

Here is mine turned 2 turns out

Sent from my iPhone using Tapatalk

 

[Ho5tile1]

Hope that helps ya them dame bolts are hard to turn out and back in lol


Sent from my iPhone using Tapatalk

 

[sndmn11]

Hope that helps ya them dame bolts are hard to turn out and back in lol


Sent from my iPhone using Tapatalk

That was my next question! It came when I was 3 weeks post surgery and trying to turn the first limb bolts sent a jolt in me.

You've got about 1/8" overhang of that washer piece?

 

[TheTone]

Shot a loaded one at my local shop the other day and kinda wish I didn’t. Definitely a great feeling bow. I really love my v3x and don’t want to be shopping for a while

 

[Ho5tile1]

Mine is like yours about an 1/8 over……I also have the V3X and love it the draw cycle is a little different on the lift to me the lift carries the weight a little farther back then my V3X the V3X gets easier quicker then my Lift X does


Sent from my iPhone using Tapatalk