Looking for some guidance on the inline fab bases. Looking for one base to mount 3 presses via the quick change top plate. The presses are
Mec marksman
Frankford m press
Lee pro 1000 progressive
The mec marksman ram/bottom of handle extends down past the "base" of the press 7ish inches. I believe the lee pro 1000 will too(maybe not 7 inches though) but I haven't recieved it yet to check it out. The m-press is all above the base of the press itself with handle on top (like a coax).
The 9" base from inline fab would put my m-press far to tall to be usable. So im kinda thinking the 4" base would work. If I mount one of the smaller bases on the edge of my reloading table, with the quick change plate, would it extend the presses with lower handles/ rams past the edge of my table? Im wanting to make sure I'll have the clearance with the smaller base and i'd rather not buy two bases unless necesary.
Mec marksman
Frankford m press
Lee pro 1000 progressive
The mec marksman ram/bottom of handle extends down past the "base" of the press 7ish inches. I believe the lee pro 1000 will too(maybe not 7 inches though) but I haven't recieved it yet to check it out. The m-press is all above the base of the press itself with handle on top (like a coax).
The 9" base from inline fab would put my m-press far to tall to be usable. So im kinda thinking the 4" base would work. If I mount one of the smaller bases on the edge of my reloading table, with the quick change plate, would it extend the presses with lower handles/ rams past the edge of my table? Im wanting to make sure I'll have the clearance with the smaller base and i'd rather not buy two bases unless necesary.
