Inline fab mounts

KY_coop

WKR
Joined
Nov 29, 2018
Messages
318
Location
KY
Looking for some guidance on the inline fab bases. Looking for one base to mount 3 presses via the quick change top plate. The presses are
Mec marksman
Frankford m press
Lee pro 1000 progressive

The mec marksman ram/bottom of handle extends down past the "base" of the press 7ish inches. I believe the lee pro 1000 will too(maybe not 7 inches though) but I haven't recieved it yet to check it out. The m-press is all above the base of the press itself with handle on top (like a coax).
The 9" base from inline fab would put my m-press far to tall to be usable. So im kinda thinking the 4" base would work. If I mount one of the smaller bases on the edge of my reloading table, with the quick change plate, would it extend the presses with lower handles/ rams past the edge of my table? Im wanting to make sure I'll have the clearance with the smaller base and i'd rather not buy two bases unless necesary.
 
I have the 4" base riser. I mounted the base at the edge the loading bench. The cantilever brings it far enough forward. No problems with my Mec.
 
Back
Top