Howa Mini Rifles, Builds, and Upgrades

[Kyguy]

Buy a different lot of ammo and see if it still does it. Sometimes Hornady sends out shit. Just a fact.

 

[Choot]

Buy a different lot of ammo and see if it still does it. Sometimes Hornady sends out shit. Just a fact.

I’ll pick some up and see if it makes a difference. I bought 3 or 4 boxes from the same lot and it didn’t do it till part way thru the last box

 

[mahonsr]

Ergos are nice think you will like it. Finish is typical stockys and ideally the lug should be bedded as it floats in stockys inlet (no idea why @Stockys thinks this is a good idea but it should be supported where the action screws atrach). The LOP is short and with some scope options this is a hassle (the maven. I would quite like to get my hands on a non inletted one as the form seems like it would work great from the kimber.

Have many more details on bedding in the luggage area? How did you get it to align and hold the action in place? Did you use the action screws?

 

[The Guide]

I’ll pick some up and see if it makes a difference. I bought 3 or 4 boxes from the same lot and it didn’t do it till part way thru the last box

This is also a potential indicator of a carbon ring forming. Might be a good time to deep clean the chamber and throat.

Jay

 

[Stocky]

Have many more details on bedding in the luggage area? How did you get it to align and hold the action in place? Did you use the action screws?

Held with surgical tubing stretched gently around the action and stock. Its not much different from normal bedding except got to be more careful of keeping bedding out of the action screw threads and that you want it to bear on the lug (as thats where the screw is).

I Just threaded up a stud the last 2 times but a bit of threaded rod or the action screws wrapped in 2 bits of heat shrink (to oversize it and stop it getting locked up works fine. Then once done I relieved the area behind the lug so it bears on the lug like in the factory stocks. Ideally I would have installed pillars but hasnt appeared to need them. Otherwise they noticeably flex the action at any half decent torque.