Help choose new cartridge.

[mlawrence125]

You have 284 win brass on hand and both 338 federal and 338 RCM are on your list. 338-284 lands you between the Federal and the RCM, and works great in a short barrel.


Sent from my iPhone using Tapatalk

Do you have any experience with that wildcat? I was looking at the 284 variants and it definitely is a consideration, would need to find dies and a barrel maker for it though as its not very common

 

[HandgunHTR]

The 25CM will work for elk and moose just fine.

If you just have to have another setup for that action, then my vote would be for a 7-08AI or 7SAW.

 

[wyosam]

Do you have any experience with that wildcat? I was looking at the 284 variants and it definitely is a consideration, would need to find dies and a barrel maker for it though as its not very common

I do. I had one done by McGowan. 4D has a reamer, so pretty easy for a smith to get a hold of it. Strangely enough, Carbon 6 has it as an available chambering without extra charge. Die’s were straightforward to get, though expensive (Redding has them on their list of available, but still have to pay the custom fee). I had Lee make a factory crimp die (I crimp hammer bullets). Think I’m going to have a Lee collet neck sizer made as well. Those are just a really nice way to process reduced cast loads since they never really grow anyway. Mine is on a tikka action, so I have plenty of length, but I think everything I’ve shot through it would fit in your magazine length. I thought about extending the throat a little to seat bullets a little longer, but there wasn’t really much to gain and it shoots too good to mess with it.


Sent from my iPhone using Tapatalk

 

[Nessie85]

The .375 Raptor sounds pretty neat....