Dialing in my bow help

[rspecht55]

Matthews Phase4 33
28.5 in draw length
60 pound draw weight
Easton axis 5.0 at 425 grains total
Hamakea rest
HHA single pin nytrx slider

Before I start I had everything paper tuned and set up with my archery shop. I am a novice when it comes to tuning.

Ok my windage on my site I have run out of room. My sight is partially covering the riser and in order to get all this to work my peep site is not aligned with my scope. I am having to compromise my peep visual to get my arrows on target. What are my next steps to get this right besides taking it to an archery shop?

When at the bow shop they moved top hats and everything to get me shooting through paper right.

Thanks for the help!


Sent from my iPhone using Tapatalk

 

[Mighty Mouse]

What's the centershot measurement of your rest (horizontal distance from center of rest fork to inside of riser)?

 

[rspecht55]

3/4 inch. This is probably my problem.


Sent from my iPhone using Tapatalk

 

[Wheels]

3/4 inch. This is probably my problem.


Sent from my iPhone using Tapatalk

You are only 1/16 off recommended, probably not the problem.

 

[midwestbowman]

Disclaimer: I am by no means a professional or expert. Just a regular dude with no archery shop nearby who like to bang his head against the wall.

If the shop did tune your bow, centershot is good, then I would not change anything on that front and I would look harder at your bow sight. Maybe try shooting some bare shafts and fletched field points to confirm the tune.

It might have a coarse adjustment where you have to change where the housing is mounted, not familiar with the HHA sights though. It is worth a check to see if it would help with running out of adjustment.

If you have Matthews, I would see if you can get a bridgelock mount for your sight. This will bring the entire sight to the left giving you more room to adjust to the right on the bow sight. This could help with your riser covering the housing some in your sight picture because from what I have seen, you can move the bridgelock sights further away or closer to the riser. I did this with my old MBG ascent verdict when I got my V3X fighting a similar issue. I will say that my housing is still covered a smidge by my riser, but not to any ill effect.

What spine are your arrows?