Dear Tikka….if you’re listening.

How has no one mentioned a 300 PRC? Give me a roughtech or a stainless lite/superlite with a threaded barrel. 24-26 inch

I would buy one tomorrow
 
They listened on the 20” threaded .223. As promised, I picked one up this weekend. Here’s hoping they listen on the 6CM.

Was hoping they'd end up being a 1:7.5 twist over the 1:8 if they did do a 6CM... I guess beggars can't be choosers but with a 1:8 I could've had a .243 rechambered and already been shooting 6CM. Maybe that's exactly why they'll go 1:8, they're already set up for it.

Really I just want to shoot factory 108gr ELD-M so if 1:8 can accomplish that, good enough for me.
 
Was hoping they'd end up being a 1:7.5 twist over the 1:8 if they did do a 6CM... I guess beggars can't be choosers but with a 1:8 I could've had a .243 rechambered and already been shooting 6CM. Maybe that's exactly why they'll go 1:8, they're already set up for it.
There's no 'already set up' for a cold hammer-forged barrel. Make a mandrel, use it until it wears out, make another. I'm not sure how much (if any) of the chamber Sako includes on their mandrels.
 
There's no 'already set up' for a cold hammer-forged barrel. Make a mandrel, use it until it wears out, make another. I'm not sure how much (if any) of the chamber Sako includes on their mandrels.

Being as making different length actions is too much to ask I wouldn't be surprised if they'd just use the same barrels they already make for 243 with the only changes being to chamber and maybe m+ mag rather than m.
 
Back
Top