DA Nomad Ti XC vs. DD Wolf Hunter

[ScreamingPotato]

I’m mostly sold on a xc lti but I’m a little irritated by the only config being with Xeno that adds weight, length, and cost to the equation not to mention that none of my other rifles are going to have that waste of time, money, weight, and length on them.

I'll trade you a new 5/8 DT hub for the Xeno hub. I wanna put a QD on my wife's Otter Creek for her two guns so she can bounce back and forth more easily.

 

[ChrisAU]

I’m mostly sold on a xc lti but I’m a little irritated by the only config being with Xeno that adds weight, length, and cost to the equation not to mention that none of my other rifles are going to have that waste of time, money, weight, and length on them.

I was annoyed to pay the extra $ at first for the Xeno setup but then I discovered they are easily sellable for $100+ and I had a bunch of HUB mounts already. So it actually lowered the cost of of the suppressor for me.

 

[Lawnboi]

7" suppressors don't belong on cases over 80gr powder capacity in my opinion. I haven't put the LTI XC on my Norma mag yet.

The Tbac brake cans might change that. From what I’m seeing with a Magnus K RR I think an S RR would be usable and quiet enough for use on some bigger guns.

Personally I don’t even like anything over a creedmoor with a 7” suppressor.

 

[khuber84]

The Tbac brake cans might change that. From what I’m seeing with a Magnus K RR I think an S RR would be usable and quiet enough for use on some bigger guns.

Personally I don’t even like anything over a creedmoor with a 7” suppressor.

These cans with integral baffle brakes are not hearing safe in my opinion. I was around some TBAC RR, a419 maverick and a few other this last weekend. Takes away most the concussion, but NOT hearing safe. My Ti XC w/ ebrake was def quieter than the magnus RR that was in the squad.

 

[Lawnboi]

These cans with integral baffle brakes are not hearing safe in my opinion. I was around some TBAC RR, a419 maverick and a few other this last weekend. Takes away most the concussion, but NOT hearing safe. My Ti XC w/ ebrake was def quieter than the magnus RR that was in the squad.

I don’t think they are hearing safe either. I only have a k rr. I’m curious to hear the S or full size. I know it’s not right but I’d shoot the K RR without ear pro for a few shots… it’s not bare muzzle loud but I wouldn’t call it normal brake noise, that’s after shooting it bunch on a 3006. Recoil reduction is very good on that rifle.

I’m real curious on what the full size RR sounds like on a decent size case.

 

[Gynaroo]

I'll trade you a new 5/8 DT hub for the Xeno hub. I wanna put a QD on my wife's Otter Creek for her two guns so she can bounce back and forth more easily.

Which direct thread hub are you looking to move?

 

[ScreamingPotato]

Which direct thread hub are you looking to move?

I have a 5/8x24 Dead Air hub. I bought it for the wife's can because her two rifles are 1/2 and 5/8 but after the fact I think I'm better off with the Xeno system for her than switching out hubs all the time. Looks like it's the LT302. Her Otter Creek came with a 1/2x28 DT hub, probably not gonna need that either if I do the Xeno.

 

[Gynaroo]

I have a 5/8x24 Dead Air hub. I bought it for the wife's can because her two rifles are 1/2 and 5/8 but after the fact I think I'm better off with the Xeno system for her than switching out hubs all the time. Looks like it's the LT302. Her Otter Creek came with a 1/2x28 DT hub, probably not gonna need that either if I do the Xeno.

PM me. I would consider switching a Xeno for the 5/8x24 DT hub for the right arrangement. I have a Lazarus 6 and a Nomad Ti Xc.

Are you looking for the break/flash hider and Xeno?