Cutting down pic rail

[onlybrowning]

Is there any reason that I may not be aware of that would cause a problem cutting a one piece pic rail into two pieces, as long as both front and back have the screws in tact? I’ve trimmed the front end overhang off of rails in the past, but not separated a one piece into two, eliminating the center over the action. Seems like it would be totally fine, assuming it’s not a huge leverage scenario like a diving board.


Sent from my iPhone using Tapatalk

 

[WeiserBucks]

Alignment due to tolerances is a consideration.

 

[sndmn11]

Glued?

 

[hereinaz]

If it had MOA, could cause alignment issues, taking it on and off.

I have considered doing it, but would bed it or glue it permanently.