Convince me to shoot monolithics again

And then this pops up in my feed just now: 212gr 308 pushed @ 2600 from a 22" barrel by the same guy.

Kinda wonky, but okay, I like the concept and line of thinking. Makes me slightly rethink my 30SM 208 @ 2920 because the 212 LRX's downrange BC (0.705 212 vs 0.633 208 vs 0.541 190 LRX) ... while the 212/308 is slower at closer/hunting ranges, if recoil is only "308-ish" it's likely super-good-enough (thanks HowNot2) for hunting, but then as you push it out the 212's slippery nature takes over. And the 308 case is less than the 30 SM case capacity, though those 212s are more expensive per bullet.

Fun stuff.

The recoil is definitely not “308’ish” with that load. Very heavy bullets wity relatively high MV, in 308’s has been done for a while; e.g. 185gr Juggs at 2,800+ fps, 208’s at 2,650fps, etc. They recoil like a 30cal that has 2,800fps MV with heavy bullets.
 
Unless required by law. I would NEVER shoot a mono for any reason. Ever.

Sent from my SM-S931U using Tapatalk
 
The recoil is definitely not “308’ish” with that load. Very heavy bullets wity relatively high MV, in 308’s has been done for a while; e.g. 185gr Juggs at 2,800+ fps, 208’s at 2,650fps, etc. They recoil like a 30cal that has 2,800fps MV with heavy bullets.
Be interesting to test one of the early theories about reduced recoil due to decreased lands-friction due to the minimized surface area of the "bore rider" design. You're still up against physics with Newton's third law, but with a decrease in friction it could considerably alter the feel if the bullet's bearing surface area is decreased.

And by "308-ish" I was referring to "not 30 SM". 308 with 165 feels different than 308 with 212, sure, but they're still burning way less powder and kicking less than a 300WM/30SM/300PRC. Apologies for that lack of clarity.

Cheers,
-mox
 
Back
Top