Capping windage turret on SWFA fixed power scopes

[westsloper]

Have any of you put a rubber cap on the windage turret on your SWFA scope? My new Tikka is ejecting brass into the turret, which occasionally sends it bouncing back into the chamber. I've had to go with some really high rings to make it work. I'd love to get the scope mounted a little lower.

Could capping the windage turret be a solution? For those of you who have done it, what did you use? Do you find it to be a solid long-term setup that can hold up to abuse?

 

[sndmn11]

Have any of you put a rubber cap on the windage turret on your SWFA scope?

Yes, all of them.

 

[matthewmt]

What caps are you using?

Sent from my SM-G973U using Tapatalk

 

[Steve300xcw]

I've 2 tikkas with low rings that have no problems, and one that does. I wont be pulling the windage knob off

Seems a guy could pull some tension outta the ejector spring and get it to where it isnt throwing brass so hard. Would rather fix the problem than pull parts off.

 

[sndmn11]

What caps are you using?

Sent from my SM-G973U using Tapatalk

https://www.amazon.com/gp/aw/d/B08KW3BDWD?psc=1&ref=ppx_pop_mob_b_asin_title

+ Tape

 

[Drumstick63]

https://www.amazon.com/gp/aw/d/B08KW3BDWD?psc=1&ref=ppx_pop_mob_b_asin_title

+ Tape
View attachment 682833

Are you using the 7/8" (22mm) size?

 

[sndmn11]

Are you using the 7/8" (22mm) size?

Yes, that link is what was in my last orders, so it's the exact thing in the picture.

 

[Drumstick63]

Yes, that link is what was in my last orders, so it's the exact thing in the picture.

Thanks!

 

[nm.otter]

After a couple of weeks with the 6x42 Gen2 it occurred to me that it might be possible to cut and re-thread a factory turret cap so it just covered the exposed brass bits.