So I'm shooting a "perfect" spine according to the software. When I set center shot I get a left tear with bare shaft at 10'. So I started moving the rest to the right to correct the tear but then my center shot was way off to the right....I then thought about hand torque. I set center shot back and experimented with torquing the bow left then right. I could produce a hard left tear and then with torquing the opposite direction could produce a right tear....So should I just keep center shot in the middle and experiment with hand positions to get a bullet hole????? Does this mean I can learn the correct grip for my bow (bowtech cpxl) by paper results with a bare shaft? Thanks in advance.