bullet selection for mountain goat

Chiming in late, but I took my first goat with a 127gr LRX from a 6.5 CM (partner followed up a second later with a 180gr Partition from his .300 WM). Both shots were in the lungs, just behind the shoulder. That billy took a few steps and fell. My second was with two 168gr TTSXs from a .30-06, first through the lungs, and my second shot went a tad high and broke the spine. He fell, but thankfully toward me and in recoverable country.
This year's goat I took with one shot from a 6.5 CM, 140gr Tipped Gameking, dropped on the spot.

I'll second what others said about making sure you shoot a goat where you can recover said goat.
 
** This will be my first mountain goat hunt. I'm between the 7 prc and the 300 win, what bullets are you guys using?

Any factory load in the 7PRC will be incredibly effective on Mt. Goat.

If I were using my 300 Win, I would shoot Federal 185 Bergers or hand loaded 200 ELDXs, because that’s what the rifle likes.

I would tend to think “elk-type bullet.” Accubond, Partition, LRX/TTSX are all rarely poor choices for any game so long as impact velocities are appropriate.


>>>——JAKE——>
 
As mentioned by the others above , knowing when and when not to shoot is most important. As you can see by the varied responses here it doesn't take a whole lot of gun to put these things down. Unless your going solo in griz country your legs and hips will thank you for carrying a 6lb 6.5 or 7mm08 rather than a 9 lb 300WM. At least mine do. YMMV
 
I used a 200gr Accubond out of my 300 WSM starting at a hair over 2,900 on my recent goat hunt. Shots were all sub 150 yards and I was surprised to have recovered two of the three bullets. Damage was significant and I would not hesitate to use them again although I do wonder how my load with 215 Bergers would have faired. Accubonds.jpg
 
Regardless of the two rifles spoken be sure to choose a well constructed, bonded, accurate bullet. I chose the 180 grain Accubond. One and done. Luck? Perhaps! But, be aware that mountain goats can absorb significant punishment. I took my Remington 700, 30WSM. One and done.


I wanted to hunt mountain goats..
For my sins I drew a tag…
Enjoy the hunt…
Endure the pain…
Cherish the memories…
 

Attachments

  • IMG_2455.jpeg
    IMG_2455.jpeg
    361.6 KB · Views: 56
Sample size of one. 140 grain Sierra Tipped GameKing in .270 Winchester worked splendidly. I have the kill shot on video. I may post it when I get back to town.
 
Just hammered a Billy at 425 yard with 156 grain Berger out of a 6.5 PRC. Took two step and tipped over.


Sent from my iPhone using Tapatalk
 
While I haven’t hunted mountain goat, I did take a mid-Asian ibex, which is similar in toughness and terrain. At 300 meters, one shot from my .270 Win with a 130-grain GMX was all it took. The bullet went straight through his lungs, and he toppled off the mountain, coming to rest halfway down. When I butchered him, his lungs were like jelly—a testament to the bullet’s impact and effectiveness at that range.

I always listen to the old timers " use what you are comfortable with, but ensure you hit them in the vitals " Any sensible calibre will do with a good bullet and shot placement. ( TTSX , GMX , CX , accubond long range , Swift a frame )

Best of luck. Happy Hunting
 
Last edited:
.270Win, .264Win Mag, 280AI, 6.5 Creedmoor, 25-06, 300PRC, .27 Nosler, all fall into a flat shooting well suited mountain cartridge.

Find a decent weight rifle you like and don’t add too much scope weight too it and you’ll be in the money for years to come.
 
.270Win, .264Win Mag, 280AI, 6.5 Creedmoor, 25-06, 300PRC, .27 Nosler, all fall into a flat shooting well suited mountain cartridge.

Find a decent weight rifle you like and don’t add too much scope weight too it and you’ll be in the money for years to come.
Good advice!
 
Back
Top