philcox
WKR
@Formidilosus I have taken your "folks don't practice enough" to heart. I bought a new Tikka 223 and while I will use my 7PRC or 6.5CM for hunting, I am planning on getting a much trigger time as I can behind the 223. With that said, the reason I am not planning on shooting the 7 or 65 for the majority of practice is ammo cost. Thus my question ... do I need to "work up a load" for the 223, OR can I just get Factory (or bulk?) ammo and use that? I can get Fiocchi 50 round boxes running the 55g V-Max for $40, or I can get some Bulk (.223 5.56 55 GRAIN FMJ-BT) ammo from Lakeshore Ammo @ $450/1000. Reloading cost is not as big of an issue as the time to load is the biggest blocker for me.
I am guessing that your answer will be something like "you need to know what your system does. So whatever you use, you should make sure that rifle/ammo combo is at worst a 2.0 MOA off a bench or prone." So, is the 2.0 MOA a reasonable "pass if not" or should it be looser? (I am guessing tighter would be better, but not "required")
I had not seen this discussed before, so if it was, just point me to that thread.
Thanks.
I am guessing that your answer will be something like "you need to know what your system does. So whatever you use, you should make sure that rifle/ammo combo is at worst a 2.0 MOA off a bench or prone." So, is the 2.0 MOA a reasonable "pass if not" or should it be looser? (I am guessing tighter would be better, but not "required")
I had not seen this discussed before, so if it was, just point me to that thread.
Thanks.