6 prc brass

[Honfor500]

I'm going to be necking down 6.5 PRC to 6 PRC wondering what size bushing to use.

 

[wind gypsy]

I'm going to be necking down 6.5 PRC to 6 PRC wondering what size bushing to use.

Depends how thick the necks are on the 6.5 brass and how much neck tension you want. Also, my sole experience with simple neck down wildcats was to doing the neck down in 2 or 3 steps with progressively smaller bushings to avoid ruining brass and keeping it a little more concentric.

 

[huntnful]

I'm going to be necking down 6.5 PRC to 6 PRC wondering what size bushing to use.

.270-.271 bushing for Lapua brass. Not sure about the other brands though.

 

[Honfor500]

Ok I will be using Lapua brass

.270-.271 bushing for Lapua brass. Not sure about the other brands though.

Thanks I'm using Lapua

 

[crich]

Fwiw Im using a .268 SAC bushing and necking ADG down in 1 step with no issues then opening up to .271 with a mandrel.

 

[Honfor500]

Fwiw Im using a .268 SAC bushing and necking ADG down in 1 step with no issues then opening up to .271 with a mandrel.

Did you have to buy the SAC die?

 

[TeaGull]

Fwiw Im using a .268 SAC bushing and necking ADG down in 1 step with no issues then opening up to .271 with a mandrel.

.271 Mandrel or .241?

 

[huntnful]

.271 Mandrel or .241?

I believe he's saying he uses a mandrel that's the proper size to open the OD of the neck up to .271

 

[crich]

Did you have to buy the SAC die?

No I'm using a redding type S bushing die. I wanted the SAC die to use the tapered bushing for the shoulder to help prevent doughnuts but haven't had an issue with adjusting the die down far enough. Money well saved at this point...

.271 Mandrel or .241?

Yes I didnt explain that clearly 2 toddlers with ear infections have my brain a little fried! I use the 21st century expander mandrel die body with a .241 mandrel that happens to bring the neck OD to .271 iirc.

 

[bradb]

I would have to double check what my neck is. I used the sac and did have to cut doughnuts