6.5 saum, am I thinking about this right?

[Rugger7622]

Thank You.

 

[Article 4]

I have some 6.5 GAP 4S head stamped Hornady brass, for a new to me gun. Can I used a Hornady 7saum FLS die with the expander ball removed and a 6.5 bushing (.291ish) for setting the shoulders back and getting the neck sized down? I would then use a 6.5 turning mandrel to open the necks back up for bullet seating? I have a universal bullet seater, but could I used the 7saum seating die as well? So?

1. Can I used 7saum FLS die to bump shoulder back on 6.5 GAP brass with the right bushing?
2. Either no expander ball, or a 6.5 expander ball?
3. Can I use the 7saum seating die or do I need to use my universal?

Tim

Yes, I have a 6.5 GAP 4s and that is exactly what I do. Redding full length sizer die, 6.5 Expander ball, 289 bushing with brass turned to .013

 

[Rugger7622]

I'm hoping with head stamped 6.5 brass I won't have to do any neck trimming!

 

[Article 4]

I'm hoping with head stamped 6.5 brass I won't have to do any neck trimming!

Hornady makes some 6.5 GAP stamped brass for sale at GAP - if you want to use Hornady, which I would not recommend

 

[Rugger7622]

Thanks what I currently have.

 

[BBob]

Thanks what I currently have.

You’ll be just fine if you don’t try go wild with it.