300wsm tikka build

[Forrest84]

I’ll try to keep this as coherent as I can.

-I have a greybough phoenix 2 stock
with a CTR inlet.
-Tikka T3X laminate in 300wsm.

I was thinking I could get one of the long action AICS mag compatible bottom metals that are made to fit the factory t3x stock's and use it on the greybough that is CTR cut. Obviously some stacking tolerances there to deal with so ide give it to my smith to do the normal fitting and bedding.

This shouldn’t require anything crazy or isn’t really a problem to make work right?

 

[13bibby]

I think red snake makes one for a ctr inlet

 

[NSI]

I have the same stock setup and use an Atlasworx short AICS.

-J

 

[Forrest84]

I came up with a atlesworx dbm but my smith had to do a good bit of work on the stock to get it to fit. But it works!

 

[NSI]

I came up with a atlesworx dbm but my smith had to do a good bit of work on the stock to get it to fit. But it works!

They feed well once set up. A clarification for future readers: Atlasworx has a Proprietary AICS bottom metal which they call a T3x cut but requires substantial inletting. They also have a drop-in CTR AICS bottom metal which is what I'm using now.

-J