.223 1-8" 80gr ELDM?

[Gstew1930]

I couldnt get the 80 ELDM to shoot in my Tikka. velocity was fine. Just didnt group for shit with H4895. Small sample of 1 though

 

[xsn10s]

I couldnt get the 80 ELDM to shoot in my Tikka. velocity was fine. Just didnt group for shit with H4895. Small sample of 1 though

In the past when loading 77gr SMK's with H4895 FED 205M gave me the best groups. Along with a light Lee Factory crimp gave me the best ES/SD and groups. I haven't tried it with the new Weatherby Vanguard I got. Saving that powder as it's my last two pounds.

 

[Gstew1930]

In the past when loading 77gr SMK's with H4895 FED 205M gave me the best groups. Along with a light Lee Factory crimp gave me the best ES/SD and groups. I haven't tried it with the new Weatherby Vanguard I got. Saving that powder as it's my last two pounds.

Yeah ive had good luck with the 77 SMK's too, just not the 80 ELDM

 

[xsn10s]

Yeah ive had good luck with the 77 SMK's too, just not the 80 ELDM

Yup sometimes those barrels just like what they like. I'm about 0.025" off the lands using TAC. Near max loads during the warmer part of summer blew a primer. But just one. I had two slightly harder bolt lifts out of twenty rounds. But the barrel was new and the rest of the rounds were fine with minimal flattening of primers. Sub moa. I'll try again now that temps have started to get cooler.

 

[mustelid_master]

I’m using aftermarket mags, the Waters rifleman mags and Ascension industries. Both allow a 2.6” COAL.

Any reliability issues?

 

[FB Trout]

Any reliability issues?

No, the Waters mag is awesome, I only wish it was available in a 4 round version so it was more flush. The Ascension Industries one does fit flush and so far has been 100% reliable, but is 3d printed, so it may have issues in the future, but fingers crossed!

 

[BLJ]

No, the Waters mag is awesome, I only wish it was available in a 4 round version so it was more flush. The Ascension Industries one does fit flush and so far has been 100% reliable, but is 3d printed, so it may have issues in the future, but fingers crossed!

Are you using the mag spring from tree factory tikka mags? I’d like to find a mag spring to use in my Ascension Industries Mag’s without disassembling my factories.

 

[Pickettpuncher]

Are you using the mag spring from tree factory tikka mags? I’d like to find a mag spring to use in my Ascension Industries Mag’s without disassembling my factories.

If you find a source for springs let me know. I have three of the ascension mags but only one spring.

 

[FB Trout]

Are you using the mag spring from tree factory tikka mags? I’d like to find a mag spring to use in my Ascension Industries Mag’s without disassembling my factories.

Yes, I’m using the factory Tikka mag spring. I dont know of any other source, unfortunately.

 

[BLJ]

If you find a source for springs let me know. I have three of the ascension mags but only one spring.

Same here. I found a place selling Remington mag springs that I thought about trying. Haven’t gotten around to it.
I was hoping there was a source for Tikka springs.

 

[FB Trout]

The Ascension mags are quite good, I’ve been impressed, just wished they shipped with a spring…..