What did you do at the range today?

[NorthIdahoDude]

Experiment with 160 Accubonds in my 7mm-08 that has been unsatisfying with 140 grain anything.

44 grains of H4350 at 2.855 OAL (.100 off the lands). Accuracy looking pretty good, but velocity with this particular load is waaay low (2500 FPS). Gonna heat that up to a about 2660 and see if the accuracy remains.

 

[Chris in TN]

My dad is visiting today so I didn't want to spend a ton of time shooting, but we all went on a SxS ride and I told my daughter I'd give her one shot to show off for her grandpa.

490 yards, prone, cold bore. 16" plate. I guess it'll do.

 

[sandhillhunter]

Today at the range I shot a hole in my brother’s steel.

Working on a new load.

300 WM
210 grain Accubond
75.5 gr H1000
91 degree ambient temp
2908 avg fps

150 yards

Sent from my iPhone using Tapatalk

 

[thinhorn_AK]

I shit steel out to 400yds with my Kimber 308, loaded some 165g partitions. I was getting just a hair over 2700fps, shot a few good groups on paper too before moving to steel.

 

[dreadi]

I shit steel out to 400yds with my Kimber 308, loaded some 165g partitions. I was getting just a hair over 2700fps, shot a few good groups on paper too before moving to steel.

That had to hurt.

 

[huntsman22]

diet high in iron.....

 

[Q_Sertorius]

I’ve heard of explosive shits, but never one that went 400 yards. Nice work.

 

[thinhorn_AK]

I hate auto correct but sometimes I wish it worked a bit better.

 

[Dan Carey]

Sertorius, I notice a lot of your groups have vertical stringing. That is usually caused by shoulder pressure along with thumb pressure on the stock. Try pulling the stock to your shoulder with your fingers only the same each time.