justinspicher
WKR
I recently decided to upgrade my Ranch rifle and figured you guys would appreciate what I did. I started by painting the stock black, the tan just wasn’t doing it for me. Next I added two Spartan adaptors. One went up front and replaced the front swivel stud and the second went just in front of the magwell. To mount the rear adaptor I used the pre-drilled hole that Ruger had inside the stock, drilled it out and then picked the necessary adaptor plate an
d screwed it in. I opted to “point” the two adaptors at each other for no reason other than it looked better. Here are the results:
This is what the adaptors look like from the bottom view and the side view.
* until I took this picture, I have never noticed the angle that the front adaptor has when attached to my stock, it certainly doesn’t seem to affect my shooting.
Here is what the final product looks like on the tripod and in bipod use:
I hope this helps out some of you folks who are looking to update your Ranch Rifle.
d screwed it in. I opted to “point” the two adaptors at each other for no reason other than it looked better. Here are the results:
This is what the adaptors look like from the bottom view and the side view.
* until I took this picture, I have never noticed the angle that the front adaptor has when attached to my stock, it certainly doesn’t seem to affect my shooting.
Here is what the final product looks like on the tripod and in bipod use:
I hope this helps out some of you folks who are looking to update your Ranch Rifle.
