Unknown OG 6.5 & Airlock Zero Gravity 6.5

[Coopsdaddy]

Same ?

 

[Hurley88]

Dang that’s a hard one to answer. Speaking only to a 6CM…
Purely to knock off any decibel I can? OG65. If my barrel was 19” or more? I’d lean OG-S. If the barrel was 18” or less I’d lean OG65. They’re really close.

As far as weight…personally they’re too close to call, I can’t really feel either one of them on the gun.

I’d likely make the decision based more on my rifle collection than the two cans. If I shot a ton of 223 and also owned a 6mm rifle, I’d go OG-S. If I owned 6.5mm rifles and 6mm, then OG65.

After today though, I’m glad I picked up the OG-S. That 6ARC barrel is 18.5” and at that powder charge weight I’d definitely rather save the inch.

 

[Formidilosus]

FWIW…


The OG6-s meters less than the OG65 on 6mm and below. It also sounds better to most people on 6mm and below when two identical rifles are being shot side by side.

 

[Hurley88]

FWIW…


The OG6-s meters less than the OG65 on 6mm and below. It also sounds better to most people on 6mm and below when two identical rifles are being shot side by side.

For context I’ve only shot 20 rounds actually listening to the two and more than half were apples to oranges (6ARC vs 6CM). Only four each the one time head to head….now I want do it meaningfully haha. That one time the OG-S did have a slightly louder bark, but if that observation is outside the norm then my first thought is “small sample size”.

Could be the OG-S had way less rounds on it, could be where I was standing, didn’t have multiple opinions from different people…or I could be right & meter be damned. Dunno. Gonna dive in like with the 6.5mm cans, will post up in a few weeks.

 

[360hunter]

FWIW…


The OG6-s meters less than the OG65 on 6mm and below. It also sounds better to most people on 6mm and below when two identical rifles are being shot side by side.

Would you recommend the OG6-s over the OG65 for both a 6mm cm and a .223? Both T3x with 16” barrels.

 

[360hunter]

FWIW…


The OG6-s meters less than the OG65 on 6mm and below. It also sounds better to most people on 6mm and below when two identical rifles are being shot side by side.

Would you recommend the OG6-s over the OG65 and OG30 for both a 6mm cm and a .223? Both are T3x with 16” barrels. I already have a TI XC I use on other rifles so I’m not concerned with getting a can I can use on every gun. I plan on leaving whatever I choose on these 2 rifles. I’m more concerned with tone and overall balance and feel and not so much decibel level. I have an OG6s on order and I’m not sure if I will use it on the 6mm or the .223 but trying to figure out what I want to put on the other one.

 

[Formidilosus]

Would you recommend the OG6-s over the OG65 for both a 6mm cm and a .223? Both T3x with 16” barrels.

I would choose the OG6-S.

 

[Cory_Shoot2Hunt]

I would choose the OG6-S.

Agreed. Especially on the smaller cartridges powder wise like the 6cm, 223 etc. the 6-s is sooo handy and pleasant. It’s one of my faves on the market and I’d say that biased or not.