Hoyts n Mulies
Lil-Rokslider
Hey All,
I’ve run across a tune issue I haven’t been able to nail down. Listed below are my setup specs:
Hoyt Nitrum 34
29” Draw
65lb
Victory RIP 300 27” with standard insert/outsert
I tunes this setup and yoke adjusted to get a good bullet hole with 175 grain point weight. I had to induce positive cam lean to papertune. I then bareshafted at 20 and was about an inch right. I then tried at 30 and was consistently 8” right of my fletched arrows. I tried adjusting the rest away from the riser (left) with no measurable change. I then tried a 145 gr point weight and again no change.
I’ve never had this issue and have always been able to get bareshaft a in a 2” group with fletching at 30. Seems like any adjustments I make are not changing the GAP between fletched and bare shaft.
I’ve run across a tune issue I haven’t been able to nail down. Listed below are my setup specs:
Hoyt Nitrum 34
29” Draw
65lb
Victory RIP 300 27” with standard insert/outsert
I tunes this setup and yoke adjusted to get a good bullet hole with 175 grain point weight. I had to induce positive cam lean to papertune. I then bareshafted at 20 and was about an inch right. I then tried at 30 and was consistently 8” right of my fletched arrows. I tried adjusting the rest away from the riser (left) with no measurable change. I then tried a 145 gr point weight and again no change.
I’ve never had this issue and have always been able to get bareshaft a in a 2” group with fletching at 30. Seems like any adjustments I make are not changing the GAP between fletched and bare shaft.