Tikka ejector spring…putting it back in

[coast range]

Any special tricks to get it back in? Removing was east even though people warned against it. I took a pic of how it went it.

I didn’t check YouTube but figured it can’t be hard. Any words of wisdom? Thanks

 

[Castle Rock]

Hook a round under the extractor from the side and use it as a lever to compress the spring and pin.

 

[coast range]

Oh I like that idea thanks. Taking the day off salmon fishing today. I’ll get it back together hopefully

 

[pods8 (Rugged Stitching)]

Oh I like that idea thanks. Taking the day off salmon fishing today. I’ll get it back together hopefully

Obviously make sure the notch is lined up right. I usually put a punch in to align/hold it in place and tap in the roll pin pushing the punch out as it goes in.

 

[khuber84]

I install bolt body horizontally in a vice, I align the pin slot with the hole for passing the pin through visual before compressing. I then use a brass case to compress the ejector by placing it under the extractor, then straighting it with the bolt body. A helper is handy here. Then use a punch through the retainer Pin hole to ensure it lined up prior to pounding in the pin.